BTS7040-1EPA
PROFET™ +2 12V
Pin Configuration
3.2
Pin Definitions and Functions
Table 2
Pin
Pin Definition
Symbol
Function
EP
VS
Supply Voltage
(exposed pad)
Battery voltage
1
2
GND
Ground
Signal ground
IN
Input Channel
Digital signal to switch ON the channel (“high” active)
If not used: connect with a 10 kΩ resistor either to GND pin or to module
ground
3
4
DEN
IS
Diagnostic Enable
Digital signal to enable device diagnosis (“high” active) and to clear the
protection counter of channel
If not used: connect with a 10 kΩ resistor either to GND pin or to module
ground
SENSE current output
Analog/digital signal for diagnosis
If not used: left open
5-7, 8-11 n.c.
12-14 OUT
Not connected, internally not bonded
Output
Protected high-side power output channel1)
1) All output pins of the channel must be connected together on the PCB. All pins of the output are internally connected
together. PCB traces have to be designed to withstand the maximum current which can flow.
Data Sheet
6
Rev. 1.10
2020-12-14
INFINEON [ Infineon ]
