PROFET Data sheet BTS 6163 D
Pin
Symbol
OUT
IN
Function
1
O
I
Output; output to the load; pin 1 and 5 must be externally shorted* .
Input; activates the power switch if shorted to ground.
2
Tab/(3)
V
bb
+
Supply Voltage; positive power supply voltage; tab and pin3 are internally
shorted.
4
IS
S
Sense Output; Diagnostic feedback; provides at normal operation a sense
current proportional to the load current; in case of overload,
overtemperature and/or short circuit a defined current is provided (see
Truth Table on page 8)
5
OUT
O
Output; output to the load; pin 1 and 5 must be externally shorted* .
*) Not shorting all outputs will considerably increase the on-state resistance, reduce the peak current capability
and decrease the current sense accuracy
Maximum Ratings at Tj = 25 °C unless otherwise specified
Parameter
Symbol
Vbb
Values
Unit
V
Supply voltage (overvoltage protection see page 4)
Supply voltage for full short circuit protection 1)
62
48
70
Vbb
V
2)
Load dump protection VLoadDump = UA + Vs, UA = 24 V
RI= 2 Ω, RL= 4.4 Ω, td= 400 ms, IN= low or high
VLoad dump
V
Load current (Short-circuit current, see page 5)
Operating temperature range
Storage temperature range
IL
self-limited
-40 ...+150
-55 ...+150
A
Tj
Tstg
Ptot
°C
Power dissipation (DC)
59
W
Inductive load switch-off energy dissipation, 3)
single pulse IL = 20 A, Vbb= 24V
EAS
0.25
3.0
J
T=150 °C:
j
Electrostatic discharge capability (ESD)
(Human Body Model)
acc. ESD assn. std. S5.1-1993; R=1.5kΩ; C=100pF
VESD
kV
Current through input pin (DC)
Current through current sense pin (DC)
see internal circuit diagrams page 9
Input voltage slew rate
IIN
IIS
+15, -120
+15, -120
mA
self-limited V/µs
Vbb ≤ 16V : dVbIN / dt
Vbb > 16V 4):
20
1)
Short circuit is defined as a combination of remaining resistances and inductances. See schematic on
page11.
2)
3)
4)
VLoad dump is setup without the DUT connected to the generator per ISO 7637-1 and DIN 40839
See also diagram on page 11.
See also on page 8. Slew rate limitation can be achieved by means of using a series resistor RIN in the input
path. This resistor is also required for reverse operation. See also page 10.
Infineon Technologies AG
Page 2 of 16
2003-Oct-01
INFINEON [ Infineon ]
