ICS1893CF Data Sheet - Release
Chapter 7 Management Register Set
7.3 Register 1: Status Register
Table 7-6 lists the Status Register bits. These 16 bits of data provide an interface between the ICS1893CF
and an STA. There are two types of status bits: some report the capabilities of the port, and some indicate
the state of signals used to monitor internal circuits.
The STA accesses the Status Register using the Serial Management Interface. During a reset, the
ICS1893CF initializes the Status Register bits to pre-defined, default values.
Note: For an explanation of acronyms used in Table 7-5, see Chapter 1, “Abbreviations and Acronyms”.
Table 7-6. Status Register (Register 1 [0x01])
Bit
Definition
When Bit = 0
When Bit = 1
Ac-
cess
SF
De- Hex
fault
1.15 100Base-T4
Always 0. (Not supported.) N/A
RO
CW
CW
CW
CW
CW
CW
CW
CW
RO
–
–
–
–
–
–
–
–
–
–
0
1
7
8
0
1.14 100Base-TX full duplex Mode not supported
1.13 100Base-TX half duplex Mode not supported
Mode supported
Mode supported
Mode supported
Mode supported
N/A
1
1.12 10Base-T full duplex
1.11 10Base-T half duplex
1.10 IEEE reserved
1.9 IEEE reserved
Mode not supported
Mode not supported
Always 0
1
1
0†
0†
0†
0†
0
Always 0
N/A
1.8 IEEE reserved
Always 0
N/A
1.7 IEEE reserved
Always 0
N/A
1.6 MF Preamble
suppression
PHY requires MF
Preambles
PHY does not require
MF Preambles
1.5 Auto-Negotiation
complete
Auto-Negotiation is in
process, if enabled
Auto-Negotiation is
completed
RO
LH
0
1.4 Remote fault
No remote fault detected
Remote fault detected
RO
RO
LH
–
0
1
1.3 Auto-Negotiation ability N/A
Always 1: PHY has
9
Auto-Negotiation ability
1.2 Link status
Link is invalid/down
Link is valid/established
RO
RO
LL
0
0
1.1 Jabber detect
No jabber condition
Jabber condition
detected
LH
1.0 Extended capability
N/A
Always 1: PHY has
extended capabilities
RO
–
1
† As per the IEEE Std 802.3u, during any write operation to any bit in this register, the STA must write the default value
to all Reserved bits.
7.3.1 100Base-T4 (bit 1.15)
The STA reads this bit to learn if the ICS1893CF can support 100Base-T4 operations. Bit 1.15 of the
ICS1893CF is permanently set to logic zero, which informs an STA that the ICS1893CF cannot support
100Base-T4 operations.
ICS1893CF, Rev. J, 08/11/09
August, 2009
Copyright © 2009, Integrated Device Technology, Inc.
All rights reserved.
50
IDT [ INTEGRATED DEVICE TECHNOLOGY ]
