ICS1893BY-10 Data Sheet - Release
Chapter 4 Operating Modes Overview
4.1.2 Specific Reset Operations
This section discusses the following specific ways that the ICS1893BY-10 can be reset:
• Hardware reset (using the RESETn pin)
• Power-on reset (applying power to the ICS1893BY-10)
• Software reset (using Control Register bit 0.15)
Note: At the completion of a reset (either hardware, power-on, or software), the ICS1893BY-10 sets all
registers to their default values.
4.1.2.1 Hardware Reset
Entering Hardware Reset
Holding the active-low RESETn pin low for a minimum of five REF_IN clock cycles initiates a hardware
reset (that is, the ICS1893BY-10 enters the reset state). During reset, the ICS1893BY-10 executes the
steps listed in Section 4.1.1.1, “Entering Reset”.
Exiting Hardware Reset
After the signal on the RESETn pin transitions from a low to a high state, the ICS1893BY-10 completes in
640 ns (that is, in 16 REF_IN clocks) steps 1 through 5, listed in Section 4.1.1.2, “Exiting Reset”. After the
first five steps are completed, the Serial Management Port is ready for normal operations, but this action
does not signify the end of the reset cycle. The reset cycle completes when the transmit clock (TXCLK) and
receive clock (RXCLK) are available, which is typically 53 ms after the RESETn pin goes high. [For details
on this transition, see Section 9.5.18, “Reset: Hardware Reset and Power-Down”.]
Note:
1. The MAC/Repeater Interface is not available for use until the TXCLK and RXCLK are valid.
2. The Control Register bit 0.15 does not represent the status of a hardware reset. It is a self-clearing bit
that is used to initiate a software reset.
4.1.2.2 Power-On Reset
Entering Power-On Reset
When power is applied to the ICS1893BY-10, it waits until the potential between VDD and VSS achieves a
minimum voltage before entering reset and executing the steps listed in Section 4.1.1.1, “Entering Reset”.
After entering reset from a power-on condition, the ICS1893BY-10 remains in reset for approximately 20
µs. (For details on this transition, see Section 9.5.17, “Reset: Power-On Reset”.)
Exiting Power-On Reset
The ICS1893BY-10 automatically exits reset and performs the same steps as for a hardware reset. (See
Section 4.1.1.2, “Exiting Reset”.)
Note: The only difference between a hardware reset and a power-on reset is that during a power-on
reset, the ICS1893BY-10 isolates its RESETn input pin. All other functionality is the same. As with
a hardware reset, Control Register bit 0.15 does not represent the status of a power-on reset.
ICS1893BY-10 Rev A 3/24/04
March, 2004
Copyright © 2004, Integrated Circuit Systems, Inc.
All rights reserved.
18
ICSI [ INTEGRATED CIRCUIT SOLUTION INC ]
