RF42/43
Register 55h. Calibration Control
Bit
D7
Reserved
R
D6
xtalstarthalf
R/w
D5
Reserved
R
D4
enrcfcal
R/w
D3
rccal
R/w
D2
vcocaldp
R/w
D1
vcocal
R/w
D0
skipvco
R/w
Name
Type
Reset value = x1x00100
Bit
7
Name
Function
Reserved
xtalstarthalf
Reserved
Reserved.
6
If Set, the Xtal Wake Time Period is Halved.
Reserved.
5
RC Oscillator Fine Calibration Enable.
enrcfcal
4
3
If this bit is set to 1 then the RC oscillator performs fine calibration in every app. 30 s.
RC Calibration Force.
If setting rccal = 1 will automatically perform a forced calibration of the 32 kHz RC
Oscillator. The RC OSC will automatically be calibrated if the Wake-Up-Timer is
enabled. The calibration takes 2 ms. The 32 kHz RC oscillator must be enabled to
perform a calibration. Setting this signal from a 0 to 1 will initiate the calibration. This bit
is cleared automatically.
rccal
VCO Calibration Double Precision Enable.
When this bit is set to 1 then the VCO calibration measures longer thus
calibrates more precisely.
vcocaldp
vcocal
2
1
0
VCO Calibration Force.
If in Idle Mode and pllon = 1, setting vcocal = 1 will force a one time calibration
of the synthesizer VCO. This bit is cleared automatically.
Skip VCO Calibration.
skipvco
Setting skipvco = 1 will skip the VCO calibration when going from the Idle state
to the TX state.
87
Tel: +86-755-82973805
Fax: +86-755-82973550
E-mail: sales@hoperf.com
http://www.hoperf.com
HOPERF [ HOPERF ]
