HMC788ALP2E
v00.0913
pHEMT GAIN BLOCK
MMIC AMPLIFIER, DC - 10 GHz
Evaluation PCB
List of Materials for Evaluation PCB EV1HMC788ALP2[1]
The circuit board used in the application should use
RF circuit design techniques. Signal lines should
have 50 Ohm impedance while the package ground
leads and exposed paddle should be connected
directly to the ground plane similar to that shown.
A sufficient number of via holes should be used to
connect the top and bottom ground planes. The
evaluation board should be mounted to an appro-
priate heat sink. The evaluation circuit board shown
is available from Hittite upon request.
Item
J1 - J2
J5, J6
C1, C2
C3
Description
PC Mount SMA Connector
DC Pin
0.01 µF Capacitor, 0502 Pkg.
100 pF Capacitor, 0402 Pkg.
2.2 µF Case A Pkg.
C4
R1
0 Ohm Resistor, 0402 Pkg.
Inductor, Conical 6.35 µH
HMC788ALP2E
L1
U1
[2]
PCB
129549 Evaluation PCB
[1] Reference this number when ordering complete evaluation PCB
[2] Circuit Board Material: Rogers 4350
For price, delivery and to place orders: Hittite Microwave Corporation, 2 Elizabeth Drive, Chelmsford, MA 01824
Phone: 978-250-3343 Fax: 978-250-3373 Order On-line at www.hittite.com
Application Support: Phone: 978-250-3343 or apps@hittite.com
6
HITTITE [ HITTITE MICROWAVE CORPORATION ]
