欢迎访问ic37.com |
会员登录 免费注册
发布采购

EDC8UV7244-60JG-S 参数 Datasheet PDF下载

EDC8UV7244-60JG-S图片预览
型号: EDC8UV7244-60JG-S
PDF下载: 下载PDF文件 查看货源
内容描述: [EDO DRAM Module, 8MX72, 60ns, CMOS, PDMA168]
分类和应用: 动态存储器光电二极管内存集成电路
文件页数/大小: 8 页 / 137 K
品牌: FUJITSU [ FUJITSU COMPONENT LIMITED. ]
 浏览型号EDC8UV7244-60JG-S的Datasheet PDF文件第1页浏览型号EDC8UV7244-60JG-S的Datasheet PDF文件第2页浏览型号EDC8UV7244-60JG-S的Datasheet PDF文件第3页浏览型号EDC8UV7244-60JG-S的Datasheet PDF文件第4页浏览型号EDC8UV7244-60JG-S的Datasheet PDF文件第5页浏览型号EDC8UV7244-60JG-S的Datasheet PDF文件第7页浏览型号EDC8UV7244-60JG-S的Datasheet PDF文件第8页  
October 1996
Revision 1.0
EDC8UV724(2/4)-(60/70)(J/T)G-S
Notes:
1.
2.
3.
4.
5.
6.
7.
8.
9.
An initial pulse of at least 200
µ
s is required after power-up followed by a minimum of eight RAS* cycles before device operation
is achieved.
V
IH
(min.) and V
IL
(max.) are reference levels for measuring timing of input signals. Transition times are measured between V
IH
(min.) and V
IL
(max.) and are assumed to be 5 ns for all inputs.
Measure with a load equivalent of 2 TTL loads and 100pF.
Operation within the t
RCD
(max.) limit ensures that t
RAC
(max.) limit can be met; t
RCD
(max.) is specified as a reference point
only. If t
RCD
is greater than the specified t
RCD
(max) limit, then access time is controlled exclusively by t
CAC
.
Assumes that t
RCD
t
RACD
(max.).
This parameter defines the time at which the output achieves open circuit condition and is not referenced to V
OH
or V
OL
.
t
WCS
is a non restrictive operating parameter. It is included in the data sheet as an electrical characteristic only. If t
WCS
t
WCS
(min.) the cycle is an early write cycle and the data out pin will remain at high impedance for the duration of the cycle.
Either t
RCH
or t
RRH
must be satisfied for a read cycle.
These parameters are referenced to the CAS* leading edge in early write cycles.
10. Operation within the t
RAD
(max.) limit ensures that t
RAC
(max.) limit can be met. t
RAD
(max.) is specified as a reference point only.
If t
RAD
is greater than the specified t
RAD
(max.) limit, then access time is controlled by t
AA
.
11. Access time is determined by the longer of t
AA
, t
CAC
, or t
ACP
.
12. t
RASC
defines RAS* pulse width in fast page mode cycles.
Physical Dimensions
168-pin(84x2) 3.3V DIMM
5.250
5.171
5.014
0.158x2
Note †
1.500
0.700
0.118
1
11
40
41
84
1.450
Datum
2.150
0.250
∅0.118x2
0.050
+0.004
0.450
0.250
1.700
2.507
4.550 (Ref.)
5.014
0.350
Front View
Notes:
1.
2.
3.
All dimensions are in inches.
Pin 85 is behind pin 1 on the back side.
Thickness = 0.350" for SOJ devices
= 0.170" for TSOP devices
6
Fujitsu Microelectronics, Inc.
0.160
min