Document Reference No.: FT_000236
V2DIP1-48 VNC2-48 Development Module Datasheet Version 1.01
Clearance No.: FTDI# 153
`
1
Introduction
V2DIP1-48 module is designed to allow rapid development of designs using the VNC2-48Q IC. The
V2DIP1-48 is supplied as a PCB designed
to fit into a 24 pin 0.6” wide 0.1” pitch DIP socket.The
module
provides access to the UART, parallel FIFO, and SPI interface pins of the VNC2-48Q device, via onboard
header pins. The module has a single USB ports which is accessible via the onboard type A USB
connector.
Figure 1.1-
V2DIP1 48
The VNC2 is the second of FTDI’s Vinculum family of Embedded dual USB host controller devices.
The
VNC2 device provides USB Host interfacing capability for a variety of different USB device classes
including support for BOMS (bulk only mass storage), Printer, HID (human interface devices). For mass
storage devices such as USB Flash drives, VNC2 also transparently handles the FAT file structure.
Communication with non USB devices such as a low cost microcontroller is accomplished via either UART,
SPI or parallel FIFO interfaces. The VNC2 provides a new cost effective solution for providing USB Host
capability into products that previously did not have the hardware resources available.
The VNC2 supports the capability to enable customers to develop custom firmware using the Vinculum II
development software tool suite. The development tools support compiler, linker and debugger tools
complete within an integrated development environment (IDE).
The Vinculum-II
VNC2
family of devices are available in Pb-free (RoHS compliant) 32-lead LQFP, 32-lead
QFN, 48-lead LQFP, 48-lead QFN, 64-Lead lQFP and 64-lead QFN packages.
Copyright © 2010 Future Technology Devices International Limited
1
FTDI [ FUTURE TECHNOLOGY DEVICES INTERNATIONAL LTD. ]
