Document Reference No.: FT_000247
V2-EVAL Vinculum II Evaluation Board Datasheet Version 2.0
Clearance No.: FTDI#148
5.2.5 GPIO [32:39] Connector CN7
Figure 5.6
GPIO[32:39] Connector CN7
VCN2 Pin No
48-PIN
Connector
Signal name
IO type
Description
pin
32-PIN
64-PIN
(16)
GPIO32
1
2
3
4
5
6
7
8
9
29
30
31
32
-
15
16
18
19
-
51
52
55
56
57
58
59
60
-
IO
IO
IO
IO
IO
IO
IO
IO
-
GPIO port, data bit 32
GPIO port, data bit 33
GPIO port, data bit 34
GPIO port, data bit 35
GPIO port, data bit 36
GPIO port, data bit 37
GPIO port, data bit 38
GPIO port, data bit 39
Ground pin
(16)
GPIO33
(16)
GPIO34
(16)
GPIO35
(16)
GPIO36
(16)
GPIO37
-
-
(16)
GPIO38
-
-
(16)
GPIO39
-
-
GND
-
-
3.3V(17)
10
11
12
-
-
-
-
-
-
-
-
-
-
-
-
3.3V power rail.
Ground pin
GND
5V(18)
5V power rail.
Notes:
(16) All VNC2‟s IO pins can be driven from 3.3V LVTTL TTL logic levels.
The use of these pins for GPIO is set by the IOMUX on the VNC2 device. The pins are shared by other
connectors on the board. Care should be taken to ensure that pins are not driven from other headers on
the board.
(17) This pin is connected to 3.3V regulator output. External device can draw no more than 100mA when board
is powered from an external power supply and no more than 50mA when the board is powered from USB
bus.
(18) This pin is connected to the board‟s 5V power rail. External device can draw no more than 250mA when
board is powered from power supply and no more than 50mA when the board is powered from USB power
bus.
Table 5.5
GPIO port connector CN7
Copyright © 2010 Future Technology Devices International Limited
18