Document Reference No.: FT_000247
V2-EVAL Vinculum II Evaluation Board Datasheet Version 2.0
Clearance No.: FTDI#148
5.2.2 GPIO [8:15] Connector CN4
Figure 5.3
GPIO[8:15] Connector CN4
VCN2 Pin No
Connector
IO
Signal name
Description
GPIO port, data bit 8
pin
type
32-PIN
48-PIN
64-PIN
(6)
GPIO8
1
2
3
4
5
6
7
8
9
-
-
19
IO
IO
IO
IO
IO
IO
IO
IO
-
(6)
GPIO9
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
20
22
23
24
25
26
27
-
GPIO port, data bit 9
GPIO port, data bit 10
GPIO port, data bit11
GPIO port, data bit 12
GPIO port, data bit 13
GPIO port, data bit 14
GPIO port, data bit 15
Ground pin
(6)
GPIO10
(6)
GPIO11
(6)
GPIO12
(6)
GPIO13
(6)
GPIO14
(6)
GPIO15
GND
3.3V(7)
10
11
12
-
-
-
-
-
-
-
-
-
-
-
-
3.3V power rail.
Ground pin
GND
5V(8)
5V power rail.
Notes:
(6)
All VNC2‟s IO pins can be driven from 3.3V LVTTL TTL logic levels.
The use of these pins for GPIO is set by the IOMUX on the VNC2 device. The pins are shared by other
connectors on the board. Care should be taken to ensure that pins are not driven from other headers
on the board.
This pin is connected to 3.3V regulator output. External device can draw no more than 100mA when
board is powered from an external power supply and no more than 50mA when the board is powered
from USB bus.
This pin is connected to the board‟s 5V power rail. External device can draw no more than 250mA when
board is powered from an external power supply and no more than 50mA when the board is powered
from USB bus.
(7)
(8)
Table 5.2
GPIO[8:15] connector CN4
Copyright © 2010 Future Technology Devices International Limited
15
FTDI [ FUTURE TECHNOLOGY DEVICES INTERNATIONAL LTD. ]
