128 KByte Flash Module (S12FTMRC128K1V1)
Table 13-57. Valid Set Field Margin Level Settings
CCOB
(CCOBIX=001)
Level Description
0x0000
0x0001
0x0002
0x0003
0x0004
Return to Normal Level
User Margin-1 Level(1)
User Margin-0 Level(2)
Field Margin-1 Level1
Field Margin-0 Level2
1. Read margin to the erased state
2. Read margin to the programmed state
Table 13-58. Set Field Margin Level Command Error Handling
Register
Error Bit
Error Condition
Set if CCOBIX[2:0] != 001 at command launch
Set if command not available in current mode (see Table 13-27)
ACCERR
Set if an invalid global address [17:16] is supplied
FSTAT
Set if an invalid margin level setting is supplied
FPVIOL
MGSTAT1
MGSTAT0
None
None
None
CAUTION
Field margin levels must only be used during verify of the initial factory
programming.
NOTE
Field margin levels can be used to check that Flash memory contents have
adequate margin for data retention at the normal level setting. If unexpected
results are encountered when checking Flash memory contents at field
margin levels, the Flash memory contents should be erased and
reprogrammed.
13.4.5.14 Erase Verify D-Flash Section Command
The Erase Verify D-Flash Section command will verify that a section of code in the D-Flash is erased. The
Erase Verify D-Flash Section command defines the starting point of the data to be verified and the number
of words.
S12P-Family Reference Manual, Rev. 1.13
466
Freescale Semiconductor