Freescale Semiconductor, Inc.
Serial Communications Interface (SCI)
17.9.4 SCI Status Register 1
SCI status register 1 contains flags to signal these conditions:
• Transfer of SCDR data to transmit shift register complete
• Transmission complete
• Transfer of receive shift register data to SCDR complete
• Receiver input idle
• Receiver overrun
• Noisy data
• Framing error
• Parity error
Address: $0016
Bit 7
6
5
4
3
2
1
Bit 0
PE
Read: SCTE
Write:
TC
SCRF
IDLE
OR
NF
FE
Reset:
1
1
0
0
0
0
0
0
= Unimplemented
Figure 17-12. SCI Status Register 1 (SCS1)
SCTE — SCI Transmitter Empty Bit
This clearable, read-only bit is set when the SCDR transfers a
character to the transmit shift register. SCTE can generate an SCI
transmitter CPU interrupt request. When the SCTIE bit in SCC2 is set,
SCTE generates an SCI transmitter CPU interrupt request. In normal
operation, clear the SCTE bit by reading SCS1 with SCTE set and
then writing to SCDR. Reset sets the SCTE bit.
1 = SCDR data transferred to transmit shift register
0 = SCDR data not transferred to transmit shift register
TC — Transmission Complete Bit
This read-only bit is set when the SCTE bit is set, and no data,
preamble, or break character is being transmitted. TC generates an
SCI transmitter CPU interrupt request if the TCIE bit in SCC2 is also
set. TC is cleared automatically when data, preamble, or break is
Technical Data
MC68HC908AS60 — Rev. 1.0
Serial Communications Interface (SCI)
For More Information On This Product,
Go to: www.freescale.com
FREESCALE [ Freescale ]
