Freescale Semiconductor, Inc.
EEPROM-2
7.5 Low-Power Modes
The WAIT and STOP instructions can put the MCU in low
power-consumption standby modes.
7.5.1 Wait Mode
The WAIT instruction does not affect the EEPROM. It is possible to
program the EEPROM and put the MCU in wait mode. However, if the
EEPROM is inactive, power can be reduced by setting the EEOFF bit
before executing the WAIT instruction.
7.5.2 Stop Mode
The STOP instruction reduces the EEPROM power consumption to a
minimum. The STOP instruction should not be executed while the high
voltage is turned on (EEPGM = 1).
If stop mode is entered while program/erase is in progress, high voltage
will be automatically turned off. However, the EEPGM bit will remain set.
When stop mode is terminated, and if EEPGM is still set, the high voltage
will be automatically turned back on. Program/erase time will need to be
extended if program/erase is interrupted by entering stop mode.
The module requires a recovery time, tEESTOP, to stabilize after leaving
stop mode. Attempts to access the array during the recovery time will
result in unpredictable behavior.
Technical Data
MC68HC908AS60 — Rev. 1.0
EEPROM-2
For More Information On This Product,
Go to: www.freescale.com
FREESCALE [ Freescale ]
