ADDITIONAL DOCUMENTATION
THERMAL ADDENDUM (REV 3.0)
ADDITIONAL DOCUMENTATION
33982
THERMAL ADDENDUM (REV 3.0)
Introduction
This thermal addendum is provided as a supplement to the 33982 technical
datasheet. The addendum provides thermal performance information that may be
critical in the design and development of system applications. All electrical,
application, and packaging information is provided in the datasheet.
High Side Switch
Packaging and Thermal Considerations
This package is a dual die package. There are two heat sources in the package
independently heating with P1 and P2. This results in two junction temperatures,
TJ1 and TJ2, and a thermal resistance matrix with RθJAmn
.
For m, n = 1, RθJA11 is the thermal resistance from Junction 1 to the reference
PNA SUFFIX
98ARL10521D
16-PIN PQFN
12 mm x 12 mm
temperature while only heat source 1 is heating with P1.
For m = 1, n = 2, RθJA12 is the thermal resistance from Junction 1 to the
reference temperature while heat source 2 is heating with P2. This applies to RθJ21
and RθJ22, respectively.
Note For package dimensions, refer to
the 33982 data sheet.
RθJA11 RθJA12
RθJA21 RθJA22
TJ1
TJ2
P1
P2
.
=
The stated values are solely for a thermal performance comparison of one
package to another in a standardized environment. This methodology is not meant to and will not predict the performance of a
package in an application-specific environment. Stated values were obtained by measurement and simulation according to the
standards listed below.
Standards
Table 19. Thermal Performance Comparison
1 = Power Chip, 2 = Logic Chip [°C/W]
Thermal
m = 1,
n = 1
m = 1, n = 2
m = 2, n = 1
m = 2,
n = 2
Resistance
1.0
(1), (2)
R
R
R
R
20
6
16
2.0
40
39
26
73
1.0
0.2
θJAmn
1.0
(2), (3)
θJBmn
(1), (4)
53
θJAmn
0.2
(5)
<0.5
0.0
θJCmn
* All measurements
are in millimeters
Notes:
1. Per JEDEC JESD51-2 at natural convection, still air
condition.
2. 2s2p thermal test board per JEDEC JESD51-7and
JESD51-5.
3. Per JEDEC JESD51-8, with the board temperature on the
center trace near the power outputs.
4. Single layer thermal test board per JEDEC JESD51-3 and
JESD51-5.
Note: Recommended via diameter is 0.5 mm. PTH (plated through
hole) via must be plugged / filled with epoxy or solder mask in order
to minimize void formation and to avoid any solder wicking into the
via.
5. Thermal resistance between the die junction and the
exposed pad, “infinite” heat sink attached to exposed pad.
Figure 13. Surface Mount for Power PQFN
with Exposed Pads
33982
Analog Integrated Circuit Device Data
Freescale Semiconductor
32
FREESCALE [ Freescale ]
