PIN CONNECTIONS
Table 1. 33186 Pin Description(continued)
Pin
Name
Description
The Pins 4 and 5 are internally connected. These Pins supply the left high side and the analog/logic
part of the device.
4, 5, 16
VBAT
The Pin 16 supplies the right high side and the charge pump.
The Pins 4, 5 and 16 should be connected together on the printed circuit board with connections as
short as possible.
Supervision and protection functions
a) Supply voltage supervision
The supply voltage is supervised. If it is below its specific threshold, the power stages are switched
in tristate and the status flag is switched low.
If the supply voltage is over the specific threshold again, the power stage switches independently
into normal operation, according to the input Pins and the status flag is reset.
b) Thermal supervision
In case of overtemperature, the power stages are switched in tristate independent of the inputs
signals and the status flag is switched low.
If the level changes from high to low on DI1 (IN1) or low to high on DI2 (IN2), the output stage
switches on again if the temperature is below the specified limit.The status-flag is reset to high level
(Pin names in brackets refer to coding Pin = VCC).
c) Supervision of overcurrent on high sides and low sides
In case of over-current detection, the power stages are switched in tristate independent of the inputs
signals and the status flag is set.
If the level changes from high to low on DI1 (IN1) or low to high on DI2 (IN2) the output stage
switches on again and the status flag is reset to high level (Pin names in brackets refer to coding Pin
= VCC).
The output stage switches into the mode defined by the inputs Pins provided, and/if the temperature
is below the specified limits.
d) Current limiting on low sides
The maximum current which can flow under normal operating conditions is limited to Imax = 6,5 A
+/- 20%. When the maximum current value is reached, the output stages are switched tristate for a
fixed time. According to the time constant the current decreases until the next switch on occurs. See
page 8 for schematics.
Charge Pump output Pin
17
CP
A filtering capacitor (up to 33 nF) can be connected between Pin 17 and Gnd. Device can operate
without external capacitor, although Pin 17 decoupling capacitor help in noise reduction and allows
the device to perform a maximum speed, timing and PWM frequency.
33186
Analog Integrated Circuit Device Data
Freescale Semiconductor
4
FREESCALE [ Freescale ]
