ELECTRICAL CHARACTERISTICS
DYNAMIC ELECTRICAL CHARACTERISTICS
Table 5. Dynamic Electrical Characteristics (continued)
Characteristics noted under conditions 6.0 V ≤ VPWR ≤ 20 V, 3.0 V ≤ VDD ≤ 5.5 V, -40 °C ≤ TA ≤ 125 °C, GND = 0 V, unless
otherwise noted. Typical values noted reflect the approximate parameter means at TA = 25 °C under nominal conditions, unless
otherwise noted.
Characteristic
Symbol
Min
Typ
Max
Unit
PWM MODULE TIMING
Input PWM Clock Range on IN0
fIN0
7.68
1.0
100
–
–
2.0
200
–
51.2
4.0
400
1.0
+10
156
26
kHz
kHz
kHz
kHz
%
Input PWM Clock Low Frequency Detection Range on IN0(32)
Input PWM Clock High Frequency Detection Range on IN0(32)
Output PWM Frequency Range
fIN0(LOW)
fIN0(HIGH)
fPWM
Output PWM Frequency Accuracy using Calibrated Oscillator
Default Output PWM Frequency using Internal Oscillator
CS Calibration Low Minimum Time Detection Range
CS Calibration Low Maximum Tine Detection Range
AFPWM(CAL)
fPWM(0)
-10
84
–
120
20
200
–
Hz
μs
tCSB(MIN)
tCSB(MAX)
RPWM_1k
14
140
6.0
260
94
μs
Output PWM Duty-cycle Range for fpwm = 1.0 kHz for High Speed Slew
Rate(33)
%
Output PWM Duty-cycle Range for fpwm = 400 Hz(33)
Output PWM Duty-cycle Range for fpwm = 200 Hz (33)
INPUT TIMING
RPWM_400
RPWM_200
10
–
–
98
98
%
%
5.0
Direct Input Toggle Timeout
tIN
175
105
250
150
325
195
ms
ms
AUTORETRY TIMING
Autoretry Period
tAUTO
TEMPERATURE ON THE GND FLAG
Thermal Prewarning Detection(34)
Analog Temperature Feedback at TA = 25 °C with RCSNS=2.5 kΩ
Analog Temperature Feedback Derating with RCSNS=2.5 kΩ(35)
Notes
TOTWAR
110
1.15
-3.5
125
1.20
-3.7
140
1.25
-3.9
°C
V
TFEED
DTFEED
mV/°C
32. Clock Fail detector available for PWM_en bit is set to logic [1] and CLOCK_sel is set to logic [0].
33. The PWM ratio is measured at VHS = 50% of VPWR and for the default SR value. It is possible to put the device fully-on (PWM duty-cycle
100%) and fully-off (duty-cycle 0%). For values outside this range, a calibration is needed between the PWM duty-cycle programming
and the PWM on the output with R = 5.0 Ω resistive load.
L
34. Typical value guaranteed per design.
35. Value guaranteed per statistical analysis.
10XS3412
Analog Integrated Circuit Device Data
Freescale Semiconductor
18