EtronTech
7
4M x 32 LPSDRAM
EM669325
Write and AutoPrecharge command (refer to the following figure)
(RAS# = "H", CAS# = "L", WE# = "L", BS = Bank, A10 = "H", A0-A7 = Column Address)
The Write and AutoPrecharge command performs the precharge operation automatically after
the write operation. Once this command is given, any subsequent command can not occur within a
time delay of {(burst length -1) + t
WR
+ t
RP
(min.)}. At full-page burst, only the write operation is
performed in this command and the auto precharge function is ignored.
8
Mode Register Set command
(RAS# = "L", CAS# = "L", WE# = "L", BS0,1 and A11-A0 = Register Data)
The mode register stores the data for controlling the various operating modes of SDRAM. The
Mode Register Set command programs the values of CAS# latency, Addressing Mode and Burst
Length in the Mode register to make SDRAM useful for a variety of different applications. The default
values of the Mode Register after power-up are undefined; therefore this command must be issued
at the power-up sequence. The state of pins BA0,1 and A11~A0 in the same cycle is the data written
to the mode register. One clock cycle is required to complete the write in the mode register (refer to
the following figure). The contents of the mode register can be changed using the same command
and the clock cycle requirements during operation as long as all banks are in the idle state.
T0
CLK
T1
T2
T3
T4
T5
T6
T7
T8
T9
T10
tCK2
CKE
Clock min.
CS#
RAS#
CAS#
WE#
Address Key
ADDR.
DQM
t
RP
DQ
Hi-Z
PrechargeAll
Mode Register
Set Command
Any
Command
Mode Register Set Cycle (CAS# Latency = 2, 3)
Preliminary
11
Rev 0.6
Sep. 2003