Ericsson Internal
E
EPEIHLI
PRODUCT SPEC.
2 (4)
Prepared (also subject responsible if other)
No.
5/1301- BMR 451 0402 Uen
27
Technical Specification
Approved
Checked
Date
Rev
Reference
EN/LZT 146 401 R4A May 2015
BMR 451 Digital PoL Regulators
Input 4.5-14 V, Output up to 40 A / 132 W
SEC/D (Lisa Li)
See §1
2015-05-18
A
© Ericsson AB
Soldering Information - Hole Mounting
The product is also capable for plated through hole mounting
by wave or manual soldering. The pin temperature is specified
to maximum to 270°C for maximum 10 seconds.
A maximum preheat rate of 4°C/s and maximum preheat
temperature of 150°C is suggested. When soldering by hand,
care should be taken to avoid direct contact between the hot
soldering iron tip and the pins for more than a few seconds in
order to prevent overheating.
A no-clean flux is recommended to avoid entrapment of
cleaning fluids in cavities inside the product or between the
product and the host board. The cleaning residues may affect
long time reliability and isolation voltage.
Delivery Package Information (Only for
BMR4510402)
The products are delivered in antistatic carrier tape
(EIA 481 standard).
Carrier Tape Specifications
Material
Antistatic PS
Surface resistance
Bakeability
<107Ohm/square
The tape is not bakable
56 mm [2.20 inch]
32 mm [1.26 inch]
13 mm [0.51 inch]
381 mm [15 inch]
130 products /reel
1.8 kg/full reel
Tape width, W
Pocket pitch, P1
Pocket depth, K0
Reel diameter
Reel capacity
Reel weight
ERICSSON [ ERICSSON ]
