EN25QH32
Table 4A. Instruction Set
Instruction Name
Byte 1
Code
Byte 2
Byte 3
Byte 4
Byte 5
Byte 6
n-Bytes
EQPI
38h
(2)
RSTQIO
Release Quad I/O or
Fast Read Enhanced
Mode
FFh
RSTEN
66h
99h
06h
(1)
RST
Write Enable
Write Disable / Exit
OTP mode
Read Status
Register
Write Status
Register
04h
05h
01h
(3)
(S7-S0)
S7-S0
(4)
continuous
A23-A16
A23-A16
A23-A16
A15-A8
A15-A8
A15-A8
A7-A0
A7-A0
A7-A0
D7-D0
Next byte continuous
Page Program
Sector Erase
Block Erase
02h
20h
D8h
Chip Erase
C7h/ 60h
B9h
Deep Power-down
(5)
Release from Deep
Power-down, and
read Device ID
Release from Deep
Power-down
dummy
dummy
dummy
(ID7-ID0)
ABh
(6)
00h
01h
(M7-M0)
(ID7-ID0)
(ID7-ID0)
(M7-M0)
Manufacturer/
Device ID
dummy
dummy
90h
(M7-M0)
(ID15-ID8)
(ID7-ID0) (7)
Read Identification
Enter OTP mode
9Fh
3Ah
Read SFDP mode
and Unique ID
Number
(Next Byte)
continuous
A23-A16
A15-A8
A7-A0
dummy
(D7-D0)
5Ah
Notes:
1. RST command only executed if RSTEN command is executed first. Any intervening command will disable Reset.
2. Device accepts eight-clocks command in Standard SPI mode, or two-clocks command in Quad SPI mode
3. Data bytes are shifted with Most Significant Bit first. Byte fields with data in parenthesis “( )” indicate data being read from the
device on the DO pin
4. The Status Register contents will repeat continuously until CS# terminate the instruction
5. The Device ID will repeat continuously until CS# terminates the instruction
6. The Manufacturer ID and Device ID bytes will repeat continuously until CS# terminates the instruction.
00h on Byte 4 starts with MID and alternate with DID, 01h on Byte 4 starts with DID and alternate with MID
7. (M7-M0) : Manufacturer, (ID15-ID8) : Memory Type, (ID7-ID0) : Memory Capacity
This Data Sheet may be revised by subsequent versions
or modifications due to changes in technical specifications.
©2004 Eon Silicon Solution, Inc., www.eonssi.com
13
Rev. E, Issue Date: 2012/01/30
EON [ EON SILICON SOLUTION INC. ]
