ePVP6800
VFD Controller
8.1.4 Address Setting Command [11]
This command sets an address of the display memory. When power is turned “ON”, the default
address is set to 00H.
MSB b7 b6 b5 b4 b3 b2 b1 b0 LSB
1
0
0
0
0
Initial value
1
0
0
Address ( 00H – 0BH )
Fig. 11 Address Setting Command Selection
If address 39H or higher is set, the data is ignored until a correct address is set.
34 of 47 11. 28.2004 (V1.23)
This specification is subject to change without further notice.