EBE11UD8AGSA
-6E
667
min.
-5C
Frequency (Mbps)
533
Parameter
Symbol
tWTR
max.
min.
7.5
max.
Unit
ns
Notes
Internal write to read command delay
7.5
Internal read to precharge command delay tRTP
7.5
7.5
ns
Exit self refresh to a non-read command
Exit self refresh to a read command
tXSNR
tRFC + 10
200
tRFC + 10
200
ns
tXSRD
tXP
tCK
Exit precharge power down to any non-read
command
2
2
tCK
tCK
tCK
Exit active power down to read command
tXARD
tXARDS
2
2
3
Exit active power down to read command
(slow exit/low power mode)
7− AL
6 − AL
2, 3
CKE minimum pulse width (high and low
pulse width)
tCKE
tOIT
3
3
tCK
ns
Output impedance test driver delay
0
12
0
12
Auto refresh to active/auto refresh
command time
tRFC
105
105
ns
Average periodic refresh interval
(0°C ≤ TC ≤ +85°C)
tREFI
7.8
3.9
7.8
3.9
µs
µs
ns
(+85°C < TC ≤ +95°C)
tREFI
Minimum time clocks remains ON after CKE
asynchronously drops low
tIS + tCK +
tIH
tIS + tCK +
tIH
tDELAY
Notes: 1. For each of the terms above, if not already an integer, round to the next higher integer.
2. AL: Additive Latency.
3. MRS A12 bit defines which active power down exit timing to be applied.
4. The figures of Input Waveform Timing 1 and 2 are referenced from the input signal crossing at the
VIH(AC) level for a rising signal and VIL(AC) for a falling signal applied to the device under test.
5. The figures of Input Waveform Timing 1 and 2 are referenced from the input signal crossing at the
VIH(DC) level for a rising signal and VIL(DC) for a falling signal applied to the device under test.
CK
DQS
/CK
/DQS
tIS
tIH
tIS
tIH
tDS tDH
tDS tDH
VDDQ
VDDQ
VIH (AC)(min.)
VIH (DC)(min.)
VREF
VIH (AC)(min.)
VIH (DC)(min.)
VREF
VIL (DC)(max.)
VIL (AC)(max.)
VSS
VIL (DC)(max.)
VIL (AC)(max.)
VSS
Input Waveform Timing 1 (tDS, tDH)
Input Waveform Timing 2 (tIS, tIH)
Data Sheet E0827E10 (Ver. 1.0)
16
ELPIDA [ ELPIDA MEMORY ]
