PRELIMINARY
CYW43438
The following sections provide an overview of the important modules in the MAC.
PSM
The programmable state machine (PSM) is a microcoded engine that provides most of the low-level control to the hardware to
implement the IEEE 802.11 specification. It is a microcontroller that is highly optimized for flow-control operations, which are predom-
inant in implementations of communication protocols. The instruction set and fundamental operations are simple and general, which
allows algorithms to be optimized until very late in the design process. It also allows for changes to the algorithms to track evolving
IEEE 802.11 specifications.
The PSM fetches instructions from the microcode memory. It uses the shared memory to obtain operands for instructions, as a data
store, and to exchange data between both the host and the MAC data pipeline (via the SHM bus). The PSM also uses a scratch-pad
memory (similar to a register bank) to store frequently accessed and temporary variables.
The PSM exercises fine-grained control over the hardware engines by programming internal hardware registers (IHR). These IHRs
are collocated with the hardware functions they control and are accessed by the PSM via the IHR bus.
The PSM fetches instructions from the microcode memory using an address determined by the program counter, an instruction literal,
or a program stack. For ALU operations, the operands are obtained from shared memory, scratch-pad memory, IHRs, or instruction
literals, and the results are written into the shared memory, scratch-pad memory, or IHRs.
There are two basic branch instructions: conditional branches and ALU-based branches. To better support the many decision points
in the IEEE 802.11 algorithms, branches can depend on either readily available signals from the hardware modules (branch condition
signals are available to the PSM without polling the IHRs) or on the results of ALU operations.
WEP
The wired equivalent privacy (WEP) engine encapsulates all the hardware accelerators to perform the encryption and decryption, as
well as the MIC computation and verification. The accelerators implement the following cipher algorithms: legacy WEP, WPA TKIP,
and WPA2 AES-CCMP.
Based on the frame type and association information, the PSM determines the appropriate cipher algorithm to be used. It supplies
the keys to the hardware engines from an on-chip key table. The WEP interfaces with the transmit engine (TXE) to encrypt and
compute the MIC on transmit frames and the receive engine (RXE) to decrypt and verify the MIC on receive frames. WAPI is also
supported.
TXE
The transmit engine (TXE) constitutes the transmit data path of the MAC. It coordinates the DMA engines to store the transmit frames
in the TXFIFO. It interfaces with WEP module to encrypt frames and transfers the frames across the MAC-PHY interface at the
appropriate time determined by the channel access mechanisms.
The data received from the DMA engines are stored in transmit FIFOs. The MAC supports multiple logical queues to support traffic
streams that have different QoS priority requirements. The PSM uses the channel access information from the IFS module to schedule
a queue from which the next frame is transmitted. Once the frame is scheduled, the TXE hardware transmits the frame based on a
precise timing trigger received from the IFS module.
The TXE module also contains the hardware that allows the rapid assembly of MPDUs into anA-MPDU for transmission. The hardware
module aggregates the encrypted MPDUs by adding appropriate headers and pad delimiters as needed.
RXE
The receive engine (RXE) constitutes the receive data path of the MAC. It interfaces with the DMAengine to drain the received frames
from the RX FIFO. It transfers bytes across the MAC-PHY interface and interfaces with the WEP module to decrypt frames. The
decrypted data is stored in the RX FIFO.
The RXE module contains programmable filters that are programmed by the PSM to accept or filter frames based on several criteria
such as receiver address, BSSID, and certain frame types.
The RXE module also contains the hardware required to detect A-MPDUs, parse the headers of the containers, and disaggregate
them into component MPDUS.
Document Number: 002-14796 Rev. *K
Page 26 of 101
CYPRESS [ CYPRESS ]
