欢迎访问ic37.com |
会员登录 免费注册
发布采购

BCM4330FKUBG 参数 Datasheet PDF下载

BCM4330FKUBG图片预览
型号: BCM4330FKUBG
PDF下载: 下载PDF文件 查看货源
内容描述: [Telecom Circuit, 1-Func, PBGA133, WLBGA-133]
分类和应用:
文件页数/大小: 168 页 / 1861 K
品牌: CYPRESS [ CYPRESS ]
 浏览型号BCM4330FKUBG的Datasheet PDF文件第145页浏览型号BCM4330FKUBG的Datasheet PDF文件第146页浏览型号BCM4330FKUBG的Datasheet PDF文件第147页浏览型号BCM4330FKUBG的Datasheet PDF文件第148页浏览型号BCM4330FKUBG的Datasheet PDF文件第150页浏览型号BCM4330FKUBG的Datasheet PDF文件第151页浏览型号BCM4330FKUBG的Datasheet PDF文件第152页浏览型号BCM4330FKUBG的Datasheet PDF文件第153页  
BCM4330 Preliminary Data Sheet  
WLAN Current Consumption  
WLAN Current Consumption  
The WLAN current consumption measurements are shown in Table 44.  
All values in Table 44 are with the Bluetooth core in reset (that is, Bluetooth and FM are off).  
Table 44: WLAN Power Consumption (Ivbat+Ivio)  
VBATT = 3.6V, VDDIO = 1.8V, TA 25°C  
WLAN  
Typical Total  
Units  
a
OFF  
10  
µA  
µA  
b
SLEEP  
Power Save  
Rx (Listen)  
Rx (Active)  
Tx CCK (21 dBm @ chip)  
180  
1.25  
52  
c, d  
mA  
mA  
mA  
mA  
mA  
mA  
e
f,g  
60  
h,i  
325  
325  
300  
h,i  
Tx OFDM, 54 Mbps (21 dBm @ chip)  
Tx MCS7 (20 dBm @ chip)  
h,i  
a. WL_REG_ON = Low, no VDDSIO  
b. Inter-beacon Sleep  
c. Beacon Interval = 102.4 ms, DTIM = 1, Beacon duration = 1 ms @1 Mbps. Integrated Sleep + wakeup + Beacon  
Rx current over 1 DTIM interval.  
d. In WLAN power save mode, the following blocks are powered down: Crystal oscillator, Baseband PLL, AFE, RF  
PLL, and the WLAN radio.  
The above blocks are turned on in the required order with sufficient time for them to settle. This sequencing  
is done by the PMU controller, which controls the settling time for each of the blocks. It also has information  
to determine the order in which the blocks should be turned on. The settling times and the dependency order  
are programmable in the PMU controller. The default CLK settling time is set to 8 ms at power-up. It can be  
reduced after power-up.  
Response: Total current consumption (at 20°C) from VBATT = 3.6V when waking up from doze for beacon  
reception:  
Sleep mode: 180 µA  
Turn on XO (~3–4 ms earlier): 3–5 mA  
Turn on BBPLL (~1 ms earlier): 10 mA  
Run BB on full clock (~1 ms earlier): 28 mA  
Turn on RFPLL(~1 ms earlier): 35 mA  
Turn on Radio–Listen (~1 ms earlier): 52 mA  
Beacon reception: 60 mA  
Back to sleep mode: 180 µA  
e. Carrier sense (CCA) when no carrier present.  
f. Carrier sense (CS) detect/packet Rx.  
g. Applicable to all supported rates.  
h. Duty cycle is 100%. Includes PA contribution at 3.6V.  
i. Absolute junction temperature limits are maintained through active thermal monitoring and dynamic Tx duty  
cycle limiting.  
®
BROADCOM  
BCM4330 Preliminary Data Sheet  
April 28, 2011 • 4330-DS304-RI  
Page 149  
 复制成功!