欢迎访问ic37.com |
会员登录 免费注册
发布采购

BCM20713 参数 Datasheet PDF下载

BCM20713图片预览
型号: BCM20713
PDF下载: 下载PDF文件 查看货源
内容描述: [Bluetooth 4.0 EDR compliant]
分类和应用:
文件页数/大小: 52 页 / 4236 K
品牌: CYPRESS [ CYPRESS ]
 浏览型号BCM20713的Datasheet PDF文件第1页浏览型号BCM20713的Datasheet PDF文件第2页浏览型号BCM20713的Datasheet PDF文件第3页浏览型号BCM20713的Datasheet PDF文件第5页浏览型号BCM20713的Datasheet PDF文件第6页浏览型号BCM20713的Datasheet PDF文件第7页浏览型号BCM20713的Datasheet PDF文件第8页浏览型号BCM20713的Datasheet PDF文件第9页  
PRELIMINARY  
CYW20713  
1. Overview  
The Cypress CYW20713 complies with the Bluetooth Core Specification, version 4.0 and is designed for use with a standard host  
controller interface (HCI) UART. The combination of the Bluetooth baseband core (BBC), a Peripheral Transport Unit (PTU), and an  
ARM-based microprocessor with on-chip ROM provides a complete lower layer Bluetooth protocol stack, including the link controller  
(LC), link manager (LM), and HCI.  
1.1 Major Features  
Major features of the CYW20713 include:  
Support for Bluetooth 4.0 + EDR, including the following options:  
Whitelist size of 25  
Enhanced Power Control  
HCI Read Encryption Key Size command  
Full support for Bluetooth 2.1 + EDR additional features:  
Secure simple pairing (SSP)  
Encryption pause resume (EPR)  
Enhance inquiry response (EIR)  
Link supervision time out (LSTO)  
Sniff subrating (SSR)  
Erroneous data (ED)  
Packet boundary flag (PBF)  
Built-in low drop-out (LDO) regulators (2)  
1.63 to 5.5V input voltage range  
1.8 to 3.3V intermediate programmable output voltage  
Integrated RF section  
Single-ended, 50 ohm RF interface  
Built-in TX/RX switch functionality  
TX Class 1 output power capability  
-88 dBm RX sensitivity basic rate  
Supports maximum Bluetooth data rates over HCI UART and SPI interfaces  
Multipoint operation, with up to seven active slaves  
Maximum of seven simultaneous active ACL links  
Maximum of three simultaneous active SCO and eSCO links, with Scatternet support  
Scatternet operation, with up to four active piconets (with background scan and support for ScatterMode)  
High-speed HCI UART transport support  
H4 five-wire UART (four signal wires, one ground wire)  
H5 three-wire UART (two signal wires, one ground wire)  
Maximum UART baud rates of 4 Mbps  
Low-power out-of-band BT_WAKE and HOST_WAKE signaling  
VSC from host transport to UART  
Proprietary compressing scheme (allows more than two simultaneous A2DP packets and up to five devices at a time)  
Channel quality-driven data rate (CQDDR) and packet type selection  
Standard Bluetooth test modes  
Extended radio and production test mode features  
Full support for power savings modes:  
Bluetooth standard hold and sniff  
Deep sleep modes and regulator shutdown  
Document Number: 002-14806 Rev. *C  
Page 4 of 52