Crane Aerospace & Electronics Power Solutions
sLH sꢂꢄglꢃ ꢀꢄꢆ dꢇꢀl dc/dc cꢈꢄvꢃꢉꢊꢃꢉ cꢀꢁꢃꢁ
28 VoLt input – 1.5 Watt
Electrical Characteristics: -55° to + 125°C Tc, 28 VDC Vin, balanced 100% load, unless otherwise specified.
ꢀotes SLH Dual Output Models:
all ꢊꢃmꢌꢃꢉꢀꢊꢇꢉꢃꢁ ꢉꢃfꢃꢉ ꢊꢈ ꢅꢀꢁꢃ ꢊꢃmꢌꢃꢉꢀꢊꢇꢉꢃ, tc
1. ꢋꢇꢀꢉꢀꢄꢊꢃꢃꢆ ꢎy ꢆꢃꢁꢂgꢄ, ꢄꢈꢊ ꢊꢃꢁꢊꢃꢆ.
6. Measured from release of inhibit until Vout settles to within 1% of final value at full
load with Vin at 28V.
2. Specified at 50%/50% balanced load.
7. Maximum specification indicates 80% of the converter’s total power is available
from either output, provided the other output carries 20% of the total power.
8. Although no minimum load is required, at no load the output voltage may exceed
rating by up to 15%.
3. With a series inductor on the Vin power lead (Lin = 6 µH).
4. Load fault is a short circuit into 1 . Recovery is into resistive full load.
5. Transition > 10 µs. Recovery is time for Vout to settle to within 1% of final value.
BOTTOM VIEW CASE A2
Projection Weld
Squared corner and dot on
top of case indicate pin one.
0.805 max. (20.45)
0.697 (17.70)
1
2
3
4
0.018 ± 0.002 dia.
(0.46 ± 0.05)
7
6
5
0.097 (2.46)
0.000
Case dimensions in inches (mm)
Tolerance ±0.005 (0.13) for three decimal places
±0.01 (0.3) for two decimal places
unless otherwise specified
CAUTION
Heat from reflow or wave soldering may damage the device.
Solder pins individually with heat application not exceeding 300°C for 10 seconds per pin
Materials
Header
Cover
Pins
Kovar/Nickel/Gold
Kovar/Nickel
Kovar/Nickel/Gold matched glass seal
Case A2, Rev D, 20081119
Please refer to the numerical dimensions for accuracy. All information is believed to be accurate,
but no responsibility is assumed for errors or omissions. Interpoint reserves the right to make
changes in products or specifications without notice.
Fi g u r e 2: Ca S e a2
www.interpoint.com
Page 7 of 10
Rev C - 20090318 - Pending Revision C Release
CRANE [ Crane Aerospace & Electronics. ]
