Crane Aerospace & Electronics Power Solutions
sFMc28-461 eMi iꢀꢁuꢂ Fꢃlꢂꢄꢅ caꢆꢄꢆ
28 Voꢇt inpꢈt – 2.7 AMp
BOTTOM VIEW CASE K2
Flanged cases: Designator “F” required in Case Option position of model number.
Seam Seal
0.040 dia
(1.02)
Dot on top of case indicates pin one
1
1.110 max. (2ꢀ.19)
0.955 (24.26)
2
3
0.162 dia
(4.11)
0.555 (14.1)
5
4
0.155 (3.94)
0.000
Seal hole: 0.120 0.002 (3.05 0.05)
Case dimensions in inches (mm)
Tolerance 0.005 (0.13) for three decimal places
0.01 (0.3) for tꢁo decimal places
unless otherꢁise specified
CAUTION
Heat from refloꢁ or ꢁave soldering may damage the device.
Solder pins individually ꢁith heat application not exceeding 300°C for 10 seconds per pin.
Materials
Header Cold Rolled Steel/Nickel/Gold
Cover Kovar/Nickel
Pins
#52 alloy/Gold ceramic seal
Case K2, Rev C, 20060110
Please refer to the numerical dimensions for accuracy. All information is believed to be accurate,
but no responsibility is assumed for errors or omissions. Interpoint reserves the right to make
changes in products or specifications ꢁithout notice.
Copyright © 1999-2006 Interpoint Corp. All rights reserved.
FIgure 7: CaSe K1
www.craneae.com
Page 8 of 11
Rev D - 20070404
CRANE [ Crane Aerospace & Electronics. ]
