TMC22091/TMC22191
PRODUCT SPECIFICATION
Pin Descriptions (continued)
Pin Number
84-Lead 100-Lead
Pin Name
OL
PLCC
MQFP
Value
Pin Function Description
29, 48-51 97, 22-25
TTL
Overlay Data Inputs (TMC22191 only). 30 of the 256
locations of the CLUT may be reserved for overlay operation.
These CLUT locations are directly accessed by five input pins,
4-0
OL . OL
are entered into the TMC22191 on a pixel-by-
pixel basis and select which of the 30 overlay colors is to be
4-0 4-0
encoded. When all five OL
occurs.
inputs are LOW, no overlay
4-0
BYPASS
28
96
TTL
CLUT Bypass Control (TMC22191 only). When BYPASS is
HIGH, the CLUT is in the pixel data path within the TMC22191.
When BYPASS is LOW, pixel data bypasses the CLUT.
BYPASS is active only for certain modes of the Layering
Control Register (LCR) when the Format Control Register bit 6
is HIGH.
Genlock Interface
GHSYNC
83
82
64
63
CMOS Genlock Horizontal Sync. In Genlock mode, the TMC22x91
will start a new horizontal line (blank-to-sync-edge transition)
with each falling edge of GHSYNC. In non-genlock modes, the
TMC22x91 ignores GHSYNC. The internal pixel clock, PCK, is
aligned with the falling edge of VHSYNC or GHSYNC (Genlock
mode).
GVSYNC
CMOS Genlock Vertical Sync. In Genlock mode, the TMC22x91 will
start a new vertical sync sequence at line 1 field 1 whenever
GVSYNC and GHSYNC are coincident such that they are
clocked into the TMC22x91 on the same rising edge of PXCK.
If GVSYNC falls at any other time, the TMC22x91 will assume
that this marks the start of field 2, and will ignore it (in odd-field
sync mode) or (in all-field sync mode) respond by generating a
single vertical sync pulse, followed by 2 (PAL) or 2.5 (NTSC)
lines of vertical sync, keyed to the next falling edge on
GHSYNC. See Interface Control Register bit 0 for odd-field and
all-field operation.
CVBS
44-47,84, 18-21,
TTL
Composite Video Inputs. The encoder receives digitized
video, subcarrier phase, and subcarrier frequency over this 8-
bit bus at the PCK rate. This data may be provided by the
companion TMC22071 Genlocking Video Digitizer. In Genlock
mode, the TMC22x91 expects subcarrier phase and frequency
data during each line’s horizontal sync interval, as well as video
data when keying is engaged, transferred at the PCK rate.
7-0
1-3
65-68
Microprocessor Interface
D
14-21
82-89
74-75
TTL
TTL
Data I/O Port. All control parameters are loaded into and read
back over this 8-bit port. For digital testing, the five lower bits
can also serve as a two-cycle 10-bit data output port. For D/A
converter testing, it can be used as a 10-bit two-cycle input
port, facilitating, for example, ramp-based D/A converter
linearity tests.
7-0
A
1-0
8-9
µProc Port Controls. As in a RAMDAC, this control governs
whether the microprocessor interface selects a table address
or reads/writes table contents. It also governs setting and
verification of the TMC22x91’s internal operating modes, also
over port D
.
7-0
8
CADEKA [ CADEKA MICROCIRCUITS LLC. ]
