ATmega48PA/88PA/168PA/328P
7.3
SRAM Data Memory
Figure 7-3 shows how the ATmega48PA/88PA/168PA/328P SRAM Memory is organized.
The ATmega48PA/88PA/168PA/328P is a complex microcontroller with more peripheral units
than can be supported within the 64 locations reserved in the Opcode for the IN and OUT
instructions. For the Extended I/O space from 0x60 - 0xFF in SRAM, only the ST/STS/STD and
LD/LDS/LDD instructions can be used.
The lower 768/1280/1280/2303 data memory locations address both the Register File, the I/O
memory, Extended I/O memory, and the internal data SRAM. The first 32 locations address the
Register File, the next 64 location the standard I/O memory, then 160 locations of Extended I/O
memory, and the next 512/1024/1024/2048 locations address the internal data SRAM.
The five different addressing modes for the data memory cover: Direct, Indirect with Displace-
ment, Indirect, Indirect with Pre-decrement, and Indirect with Post-increment. In the Register
File, registers R26 to R31 feature the indirect addressing pointer registers.
The direct addressing reaches the entire data space.
The Indirect with Displacement mode reaches 63 address locations from the base address given
by the Y- or Z-register.
When using register indirect addressing modes with automatic pre-decrement and post-incre-
ment, the address registers X, Y, and Z are decremented or incremented.
The 32 general purpose working registers, 64 I/O Registers, 160 Extended I/O Registers, and
the 512/1024/1024/2048 bytes of internal data SRAM in the ATmega48PA/88PA/168PA/328P
are all accessible through all these addressing modes. The Register File is described in ”Gen-
eral Purpose Register File” on page 11.
Figure 7-3. Data Memory Map
Data Memory
0x0000 - 0x001F
0x0020 - 0x005F
0x0060 - 0x00FF
32 Registers
64 I/O Registers
160 Ext I/O Reg.
0x0100
Internal SRAM
(512/1024/1024/2048 x 8)
0x04FF/0x04FF/0x0FF/0x08FF
18
8161D–AVR–10/09
ATMEL [ ATMEL ]
