ATmega8(L)
When changing the ACIS1/ACIS0 bits, the Analog Comparator Interrupt must be disabled by
clearing its Interrupt Enable bit in the ACSR Register. Otherwise an interrupt can occur when the
bits are changed.
Analog
Comparator
Multiplexed Input
It is possible to select any of the ADC7..0(1) pins to replace the negative input to the Analog
Comparator. The ADC multiplexer is used to select this input, and consequently the ADC must
be switched off to utilize this feature. If the Analog Comparator Multiplexer Enable bit (ACME in
SFIOR) is set and the ADC is switched off (ADEN in ADCSRA is zero), MUX2..0 in ADMUX
select the input pin to replace the negative input to the Analog Comparator, as shown in Table
72. If ACME is cleared or ADEN is set, AIN1 is applied to the negative input to the Analog
Comparator.
Table 72. Analog Comparator Multiplexed Input(1)
ACME
ADEN
MUX2..0
xxx
Analog Comparator Negative Input
0
1
1
1
1
1
1
1
1
1
x
1
0
0
0
0
0
0
0
0
AIN1
xxx
AIN1
000
ADC0
ADC1
ADC2
ADC3
ADC4
ADC5
ADC6
ADC7
001
010
011
100
101
110
111
Note:
1. ADC7..6 are only available in TQFP and QFN/MLF Package.
195
2486T–AVR–05/08
ATMEL [ ATMEL ]
