ATmega8U2/16U2/32U2
buffers.
Table 20-2. UPWE[I:0] Bits Settings
UPWE1
UPWE0
Mode
0
0
1
1
0
1
0
1
Direct drive is disabled.
Reserved
Direct drive of DP/DM (UPDRV[1:0] values)
Reserved
• Bit 5:4 – UPDRV[1:0]: USB direct drive values
These bits are relevant only when one of the direct drive modes for USB is enable. When
UPWE[1:0] is 1:0 the values of these bits are output to USB.
The value written to UPDRV1 is output to D+.
The value written to UPDRV0 is output to D-.
• Bits 3:2 – Res: Reserved
These bits are reserved and should always read as zero.
• Bit 1 – DPI: D+ Input value
This bit is read only, the value read from this bit reflects the D+ pin (USB buffer). This bit is set
one by hardware if a one logic level is read on D+. This bit is set to zero by hardware if a zero
logic level is read on D+.
• Bit 0 – DMI: D- Input value
This bit is read only, the value read from this bit reflects the D- pin (USB buffer). This bit is set
one by hardware if a logic one is read on D-. This bit is set to zero by hardware if a logic zero
logic is read on D-.
20.10.3 REGCR – Regulator Control Register
Bit
(0x63)
7
6
-
5
-
4
-
3
-
2
-
1
-
0
REGDIS
R/W
0
-
REGCR
Read/Write
Initial Value
R
0
R
0
R
0
R
0
R
0
R
0
R
0
• Bit 0 – REGDIS: Regulator Disable
Writing this bit to a logic one disables the internal 3.3V regulator. Writing this bit to a logic zero
enables the regulstor.
196
7799D–AVR–11/10
ATMEL [ ATMEL ]
