Revision 1.29 – May 07, 2008
440EP – PPC440EP Embedded Processor
Data Sheet
Signal Descriptions
The PPC440EP embedded controller is packaged in a 456-ball enhanced plastic ball grid array (E-PBGA). The
following tables describe the package level pinout.
Table 7. Pin Summary
Group
Total Signal Pins
AVDD
No. of Pins
304
1
SAVDD
1
1
SAGnd
AGnd
OVDD
1
18
SVDD
VDD
18
32
80
Gnd
Total Power Pins
Reserved
152
0
Total Pins
456
In the table “Signal Functional Description” on page 52, each I/O signal is listed along with a short description of its
function. Active-low signals (for example, RAS) are marked with an overline. Please see “Signals Listed
Alphabetically” on page 19 for the pin (ball) number to which each signal is assigned.
Multiplexed Signals
Some signals are multiplexed on the same pin so that the pin can be used for different functions. In most cases,
the signal names shown in this table are not accompanied by signal names that may be multiplexed on the same
pin. If you need to know what, if any, signals are multiplexed with a particular signal, look up the name in “Signals
Listed Alphabetically” on page 19. It is expected that in any single application a particular pin will always be
programmed to serve the same function. The flexibility of multiplexing allows a single chip to offer a richer pin
selection than would otherwise be possible. The circuit type for multiplexed signals is shown as “Multiplex.” The
actual circuit type is the same as the primary signal.
Note: Signals multiplexed with GPIO default to GPIO receivers and float after reset. Initialization software must
configure the GPIO registers for the desired function as described in the GPIO Chapter of the User’s Manual. Any
of these signals requiring a particular state prior to running initialization code must be terminated with pull ups or
pull downs.
Multipurpose Signals
In addition to multiplexing, some pins are also multi-purpose. For example, the EBC peripheral controller address
pins (PerAddr) are used as outputs by the PPC440EP to broadcast an address to external slave devices when the
PPC440EP has control of the external bus. When during the course of normal chip operation an external master
gains ownership of the external bus, these same pins are used as inputs which are driven by the external master
and received by the EBC in the PPC440EP. In this example, the pins are also bidirectional, serving both as inputs
and outputs.
50
AMCC Proprietary
AMCC [ APPLIED MICRO CIRCUITS CORPORATION ]
