Revision 1.07 – September 10, 2007
Data Sheet
Address Maps
The PPC405EP incorporates two address maps. The first address map defines the possible use of addressable
memory regions that the processor can access. The second address map defines Device Configuration Register
(DCR) addresses (numbers). The DCRs are accessed by software running on the PPC405EP processor through
the use of
mtdcr
and
mfdcr
instructions.
Table 1. System Memory Address Map (4GB System Memory)
Function
Subfunction
SDRAM, External Peripherals, and PCI
Memory
Note:
Any of the address ranges listed at
right may be use for any of the above
functions.
Peripheral Bus Boot
1
PCI Boot
2
PCI I/O
PCI I/O
PCI
Configuration Registers
Interrupt Acknowledge and Special Cycle
Local Configuration Registers
GPT
UART0
UART1
Internal Peripherals
IIC0
OPB Arbiter
GPIO Controller Registers
Ethernet 0 Controller Registers
Ethernet 1 Controller Registers
Start Address
0x00000000
0xE8010000
0xEC000000
0xEEE00000
0xEF500000
0xEF900000
0xFFE00000
0xFFFE0000
0xE8000000
0xE8800000
0xEEC00000
0xEED00000
0xEF400000
0xEF600000
0xEF600300
0xEF600400
0xEF600500
0xEF600600
0xEF600700
0xEF600800
0xEF600900
Boot-up
End Address
0xE7FFFFFF
0xE87FFFFF
0xEEBFFFFF
0xEF3FFFFF
0xEF5FFFFF
0xFFFFFFFF
0xFFFFFFFF
0xFFFFFFFF
0xE800FFFF
0xEBFFFFFF
0xEEC00007
0xEED00003
0xEF40003F
0xEF6000FF
0xEF600307
0xEF600407
0xEF60051F
0xEF60063F
0xEF60077F
0xEF6008FF
0xEF6009FF
Size
3712MB
8MB
44MB
6MB
1MB
263MB
2MB
128KB
64KB
56MB
8B
4B
64B
256B
8B
8B
32B
64B
128B
256B
256B
General Use
Notes:
1. When peripheral bus boot is selected, peripheral bank 0 is automatically configured at reset to the address range listed above.
2. If PCI boot is selected, a PLB-to-PCI mapping is automatically configured at reset to the address range listed above.
3. After the boot process, software may reassign the boot memory regions for other uses.
4. All address ranges not listed above are reserved.
6
AMCC
AMCC [ APPLIED MICRO CIRCUITS CORPORATION ]
