欢迎访问ic37.com |
会员登录 免费注册
发布采购

PPC405CR-3BC200CZ 参数 Datasheet PDF下载

PPC405CR-3BC200CZ图片预览
型号: PPC405CR-3BC200CZ
PDF下载: 下载PDF文件 查看货源
内容描述: 405CR的PowerPC嵌入式处理器 [PowerPC 405CR Embedded Processor]
分类和应用: PC
文件页数/大小: 42 页 / 820 K
品牌: AMCC [ APPLIED MICRO CIRCUITS CORPORATION ]
 浏览型号PPC405CR-3BC200CZ的Datasheet PDF文件第29页浏览型号PPC405CR-3BC200CZ的Datasheet PDF文件第30页浏览型号PPC405CR-3BC200CZ的Datasheet PDF文件第31页浏览型号PPC405CR-3BC200CZ的Datasheet PDF文件第32页浏览型号PPC405CR-3BC200CZ的Datasheet PDF文件第34页浏览型号PPC405CR-3BC200CZ的Datasheet PDF文件第35页浏览型号PPC405CR-3BC200CZ的Datasheet PDF文件第36页浏览型号PPC405CR-3BC200CZ的Datasheet PDF文件第37页  
Revision 1.02 – January 11, 2005  
PPC405CR – PowerPC 405CR Embedded Processor  
Spread Spectrum Clocking  
Data Sheet  
Care must be taken when using a spread spectrum clock generator (SSCG) with the PPC405CR. This controller  
uses a PLL for clock generation inside the chip. The accuracy with which the PLL follows the SSCG is referred to  
as tracking skew. The PLL bandwidth and phase angle determine how much tracking skew there is between the  
SSCG and the PLL for a given frequency deviation and modulation frequency. When using an SSCG with the  
PPC405CR the following conditions must be met:  
The frequency deviation must not violate the minimum clock cycle time. Therefore, when operating the  
PPC405CR with one or more internal clocks at their maximum supported frequency, the SSCG can only  
lower the frequency.  
The maximum frequency deviation cannot exceed 3%, and the modulation frequency cannot exceed  
40kHz. In some cases, on-board PPC405CR peripherals impose more stringent requirements (see Note 1).  
Use the peripheral bus clock (PerClk) for logic that is synchronous to the peripheral bus since this clock  
tracks the modulation.  
Use the SDRAM MemClkOut since it also tracks the modulation.  
Notes:  
1. The serial port baud rates are synchronous to the modulated clock. The serial port has a tolerance of approx-  
imately 1.5% on baud rate before framing errors begin to occur. The 1.5% tolerance assumes that the  
connected device is running at precise baud rates. If an external serial clock is used the baud rate is unaf-  
fected by the modulation.  
2. IIC operation is unaffected.  
Caution: It is up to the system designer to ensure that any SSCG used with the PPC405CR meets the above  
requirements and does not adversely affect other aspects of the system.  
AMCC  
33  
 复制成功!