AMG-DF102
Full Bridge MOSFET/IGBT Driver up to 600V
11. IC-Marking
ɑDF102
4 digits date code = 2 digits year + 2 digits work week
8 digits lot number = 2 digits fab process + 4 digits lot number + 1 digit sub lot
12. Ordering Information
AMG-DF102-ISP24U
AMG-DF102-ISP24R
shipment in tubes
shipment in Tape & Reel
13. Notes and Cautions
13.1. ESD Protection
The Requirements for Handling Electrostatic Discharge Sensitive Devices are described in the
JEDEC standard JESD625-A. Please note the following recommendations:
When handling the device, operators must be grounded by wearing a for the purpose
designed grounded wrist strap with at least 1MΩ resistance and direct skin contact.
Operators must at all times wear ESD protective shoes or the area should be
surrounded by for ESD protection intended floor mats.
Opening of the protective ESD package that the device is delivered in must only occur at
a properly equipped ESD workbench. The tape with which the package is held together
must be cut with a sharp cutting tool, never pulled or ripped off.
Any unnecessary contact with the device or any unprotected conductive points should be
avoided.
Work only with qualified and grounded tools, measuring equipment, casing and
workbenches.
Outside properly protected ESD-areas the device or any electronic assembly that it may
be part of should always be transported in EGB/ESD shielded packaging.
13.2. Storage conditions
The AMG-DF102 corresponds to moisture sensitivity classification ML2, according to JEDEC
standard J-STD-020, and should be handled and stored according to J-STD-033.
AMG-DF102
Revision: AB
30. Nov. 2010
© All rights reserved Page 11 of 12
ALPHA-MICRO [ ALPHA MICROELECTRONICS GMBH ]
