欢迎访问ic37.com |
会员登录 免费注册
发布采购

A4052MP8R 参数 Datasheet PDF下载

A4052MP8R图片预览
型号: A4052MP8R
PDF下载: 下载PDF文件 查看货源
内容描述: [BATTERY MANAGEMENT]
分类和应用:
文件页数/大小: 11 页 / 291 K
品牌: AITSEMI [ AiT Semiconductor ]
 浏览型号A4052MP8R的Datasheet PDF文件第1页浏览型号A4052MP8R的Datasheet PDF文件第3页浏览型号A4052MP8R的Datasheet PDF文件第4页浏览型号A4052MP8R的Datasheet PDF文件第5页浏览型号A4052MP8R的Datasheet PDF文件第6页浏览型号A4052MP8R的Datasheet PDF文件第7页浏览型号A4052MP8R的Datasheet PDF文件第8页浏览型号A4052MP8R的Datasheet PDF文件第9页  
A4052  
BATTERY MANAGEMENT  
AiT Semiconductor Inc.  
www.ait-ic.com  
1A IS COMPATIBLE WITH THE USB INTERFACE,  
LINEAR BATTERY MANAGEMENT CHIP  
PIN DESCRIPTION  
Top View  
Pin #  
1,8  
Symbol  
Function  
NC  
No Connect  
Charge current programming, charge current monitoring and close pin. Charge current  
is controlled by a resistor of precision of 1% to the ground. In the constant charge  
current state, this port provides 1V voltage. In all conditions, this port charge current  
can be calculated using the following formula:  
IBAT = (VISET/RISET) ×1000  
2
ISET  
ISET port can also be used to turn off the charger. Resistance to side with the  
separation of programming can pull the 3uA current source to increase ISET port  
voltage. When the suspension reached the limit voltage 1.21V, the device enters stop  
state, after charging the input current drop to 25A. This port pinch-off voltage is about  
2.4V. If supply this port voltage more than pinch-off voltage, the current will be 1.5mA.  
Through combinating ISET pin to the ground, the charger will back to normal.  
Ground terminal, The EXPOSED pin is also connected with pin 3.  
3
4
GND  
VIN  
Supply positive input voltage. Power supply for the charger. VCC can be 4.25V to 6.5V  
and must have at least 1F bypass capacitor. If the BAT pin voltage of VCC down to  
within 30 mV, A4052 into the suspension state, and make BAT Current less than 2A.  
Make the battery's positive terminal connected to this pin. When the power supply  
voltage lower than the threshold latch voltage or sleep mode voltage, BAT pin current  
is less than 2μA. BAT pin provide the battery charge current and constant voltage  
charging voltage.  
5
BAT  
When charging end, DONE pin is pulled low by internal switch represents that charge  
has ended; otherwise DONE pin is high impedance state.  
6
7
DONE  
CHRG  
When the charger to the battery charging, CHRG pin is pulled low by the internal  
switch, represents charging being; otherwise CHRG pin is in high impedance state.  
REV1.0  
- OCT 2013 RELEASED -  
- 2 -