欢迎访问ic37.com |
会员登录 免费注册
发布采购

A4052MP8R 参数 Datasheet PDF下载

A4052MP8R图片预览
型号: A4052MP8R
PDF下载: 下载PDF文件 查看货源
内容描述: [BATTERY MANAGEMENT]
分类和应用:
文件页数/大小: 11 页 / 291 K
品牌: AITSEMI [ AiT Semiconductor ]
 浏览型号A4052MP8R的Datasheet PDF文件第3页浏览型号A4052MP8R的Datasheet PDF文件第4页浏览型号A4052MP8R的Datasheet PDF文件第5页浏览型号A4052MP8R的Datasheet PDF文件第6页浏览型号A4052MP8R的Datasheet PDF文件第7页浏览型号A4052MP8R的Datasheet PDF文件第9页浏览型号A4052MP8R的Datasheet PDF文件第10页浏览型号A4052MP8R的Datasheet PDF文件第11页  
A4052  
BATTERY MANAGEMENT  
AiT Semiconductor Inc.  
www.ait-ic.com  
1A IS COMPATIBLE WITH THE USB INTERFACE,  
LINEAR BATTERY MANAGEMENT CHIP  
Enable design  
By controlling whether the ISET pin resistor connected, users can reach close A4052 function.  
Figure 3. A4052 Enable Design  
Open-drain output status indication  
A4052 has two open-drain status indication sides, CHAG and DONE, the two status indicator LEDs client can  
drive or microcontroller port. CHAG used to indicate charging status, charging time, CHAG is low; DONE to  
indicate the charging end of the state, when the charging end, DONE is low. When the battery temperature is  
outside the normal temperature range more than 0.15 seconds, CHAG and the DONE pin is high impedance  
output state.  
When the battery charger not received, the charger will quickly charge the output capacitor to the constant  
voltage value, as the battery voltage detection the BAT pin input leakage current, the BAT pin voltage will  
slowly down to recharge threshold, so the BAT pin voltage is 150mV to form a ripple waveform, while CHAG  
output pulse signal that there is no battery installed. When the battery BAT pin external connectors for the  
4.7uF capacitor, the pulse period of about 2Hz.  
The following table lists CHAG and DONE pin status in each case:  
State  
CHAG  
DONE  
Charge  
Always bright  
Always off  
Full  
Without Battery  
Flashing  
Error  
Always off  
Always bright  
Always off  
Always off  
Always bright  
NOTE1: CHAG flicker frequency with external capacitor when not connect battery, generally recommended  
4.7uF.The greater the capacitance, the smaller frequency flicker.  
NOTE2: The error situation: Beyond the operating temperature range (temperature too high or too low), Iset  
side vacant, VIN <VBAT, VIN <3.8V and so on.  
REV1.0  
- OCT 2013 RELEASED -  
- 8 -