Agilent 16720A Pattern Generator Specifications and Characteristics
Data Pod Characteristics
Note: Data Pod output parametrics depend on the output driver and
the impedance load of the target system. Check the device data
book for the specific drivers listed for each pod.
Agilent 10461A TTL Data Pod
100 Ω
ECL/TTL
10H125
Output type
Maximum clock
Skew [1]
10H125 with 100 Ω series
200 MHz
typical < 2 ns; worst case = 4 ns
Recommended lead set Agilent 10474A
Agilent 10462A 3-State TTL/CMOS Data Pod
100 Ω
74ACT11244
Output type
74ACT11244 with 100 Ω series;
10H125 on non 3-state channel 7 [2]
3-state enable
negative true, 100 KΩ to GND, enabled
on no connect
Maximum clock
Skew [1]
100 MHz
typical < 4 ns; worst case = 12 ns
Recommended lead set Agilent 10474A
Agilent 10464A ECL Data Pod (terminated)
42 Ω
Output type
Maximum clock
Skew [1]
10H115 with 330 Ω pulldown, 47 Ω series
10H115
348 Ω
– 5.2 V
300 MHz
typical < 1 ns; worst case = 2 ns
Recommended lead set Agilent 10474A
[1] Typical skew measurements made at pod connector with approximately 10 pF/50
KΩ load to GND; worst case skew numbers are a calculation of worst case
conditions through circuits. Both numbers apply to any channel within a single or
multiple module system.
[2] Channel 7 on the 3-state pods has been brought out in parallel as a non 3-state
signal. By looping this output back into the 3-state enable line, the channel can be
used as a 3-state enable.
24
AGILENT [ AGILENT TECHNOLOGIES, LTD. ]
