Data Sheet
CIRCUIT INFORMATION
RESET THRESHOLDS
A reset output is provided to the microprocessor whenever the
V
CC
input is below the reset threshold. The actual reset threshold
depends on whether an L, M, T, S, R, or Z suffix is used (see
Table 4. Reset Threshold Options
Model
ADM811LART
ADM811MART
ADM811TART
ADM811-3TART
ADM811SART
ADM811RART
ADM811ZART
ADM812LART
ADM812MART
ADM812TART
ADM812SART
ADM812RART
ADM812ZART
Reset Threshold (V)
4.63
4.38
3.08
3.08
2.93
2.63
2.32
4.63
4.38
3.08
2.93
2.63
2.32
ADM811/ADM812
This allows time for the power supply and microprocessor to
stabilize.
The ADM811 provides an active low reset output (RESET)
while the ADM812 provides an active high output (RESET).
During power-down of the ADM811, the RESET output
remains valid (low) with V
CC
as low as 1 V. This ensures that
the microprocessor is held in a stable shutdown condition as
the supply falls and also ensures that no spurious activity can
occur via the microprocessor as it powers up.
MANUAL RESET
The ADM811/ADM812 are equipped with a manual reset
input. This input is designed to operate in a noisy environment
where unwanted glitches could be induced. These glitches could
be produced by the bouncing action of a switch contact, or where a
manual reset switch may be located some distance away from
the circuit (the cabling of which can pick up noise).
The manual reset input is guaranteed to ignore logically valid
inputs that are faster than 100 ns and to accept inputs longer in
duration than 10 µs.
GLITCH IMMUNITY
The ADM811/ADM812 contain internal filtering circuitry
providing glitch immunity from fast transient glitches on the
power supply line.
V
CC
V
REF
V
REF
V
REF
V
REF
RESET OUTPUT
On power-up and after V
CC
rises above the reset threshold, an
internal timer holds the reset output active for 240 ms (typical).
This is intended as a power-on reset signal for the processor. It
allows time for both the power supply and the microprocessor
to stabilize after power-up. If a power supply brownout or
interruption occurs, the reset output is similarly activated and
remains active for 240 ms (typical) after the supply recovers.
RESET
t
1
t
1
00092-010
t
1
= RESET TIME = 250ms TYPICAL
V
REF
= RESET VOLTAGE THRESHOLD
Figure 10. Power Fall RESET Timing
Rev. G | Page 7 of 12
AD [ ANALOG DEVICES ]
