1.3 Absolute maximum ratings. 1/
Supply voltage (V to COM) ........................................................................................................ 68 V
S
I
voltage ................................................................................................................................. V to COM - 5.2 V
S
OUT
Reverse supply voltage (V to COM)............................................................................................ -0.3 V
S
Power dissipation (P ) ................................................................................................................. 8 mW
D
Output short circuit duration ......................................................................................................... Indefinite
Maximum junction temperature (T ) ............................................................................................. 150°C
J
Lead temperature (soldering, 10 seconds) ................................................................................... 300°C
Storage temperature range .......................................................................................................... -65°C to +150°C
Thermal resistance, junction-to-case (θ ) .................................................................................. 56°C/W 2/
JC
Thermal resistance, junction-to-ambient (θ ) ............................................................................. 93°C/W 2/
JA
1.4 Recommended operating conditions.
Supply voltage (V to COM) ........................................................................................................ 7 V to 65 V 3/
S
Ambient operating temperature range (T ) .................................................................................. -55°C to +125°C
A
1.4.1 Operating performance characteristics.
Input / output characteristics: (T = +25°C, +V to COM = 15 V)
A
S
Input impedance differential ...................................................................................................... 2 kΩ
Input impedance common mode (+V to COM = 7 V to 65 V) ................................................. 5 MΩ
S
Output impedance .................................................................................................................... 20 MΩ
Input to output transconductance ............................................................................................. 1000 µA / V
Dynamic response: (T = +25°C, +V to COM = 15 V) 4/
A
S
Small signal bandwidth - 3dB (Gain = 10) ................................................................................ 1000 kHz
Small signal bandwidth - 3dB (Gain= 20) ................................................................................. 500 kHz
Small signal bandwidth - 3dB (Gain = 50) ................................................................................ 100 kHz
Noise performance: (T = +25°C, +V to COM = 15 V)
A
S
Voltage noise (referred to input (RTI), f = 0.1 Hz to 10 Hz) ...................................................... 1.1 µVp-p
Voltage noise (referred to input (RTI), special density, f = 1 kHz) ............................................ 40 nV / Hz
______
1/ Stresses above the absolute maximum rating may cause permanent damage to the device. Extended operation at the
maximum levels may degrade performance and affect reliability. Note COM and BIAS pins can be treated as essentially
the same voltage for absolute maximum ratings.
2/ Measurement taken under absolute worse case condition of still air. Data taken with a thermal camera for highest power
density location. See MIL-STD-1835 for average package θ thermal numbers.
JC
3/ This device has high voltage operation which is achieved by using external voltage breakdown PNP transistor.
In this configuration, the common mode range of the device is equal to the breakdown of the external PNP transistor.
Refer to section 6.7 for more information.
4/ External input filtering should be considered to trade off desired dynamic response versus undesired response to system
transients and electromagnetic interference (EMI). Refer to section 6.7 for more information.
SIZE
STANDARD
5962-09244
A
MICROCIRCUIT DRAWING
DLA LAND AND MARITIME
REVISION LEVEL
B
SHEET
COLUMBUS, OHIO 43218-3990
3
DSCC FORM 2234
APR 97
ADI [ ADI ]
