1.3 Absolute maximum ratings. 1/
Supply Voltage................................................................................................................................ ±22 V
Power Dissipation........................................................................................................................... 500 mW
Output Short-Circuit to Ground ....................................................................................................... Indefinite
Input Voltage X1, X2, Y1, Y2, Z1, Z2.............................................................................................. ±VS
Storage Temperature Range .......................................................................................................... -65°C to +150°C
Lead Temperature (Soldering, 60 sec.) .......................................................................................... +300°C
Thermal resistance, junction-to-case (θJC) ..................................................................................... See MIL-STD-1835
Thermal resistance, junction-to-ambient (θJA)
Case C ..................................................................................................................................... 95°C/W
Case I ..................................................................................................................................... 142°C/W
1.4 Recommended operating conditions.
Supply Voltage................................................................................................................................ ±15 V
Operating Temperature Range....................................................................................................... -55°C to +125°C
2. APPLICABLE DOCUMENTS
2.1 Government specification, standards, and handbooks. The following specification, standards, and handbooks form a part
of this drawing to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the
solicitation or contract.
DEPARTMENT OF DEFENSE SPECIFICATION
MIL-PRF-38535 - Integrated Circuits, Manufacturing, General Specification for.
DEPARTMENT OF DEFENSE STANDARDS
MIL-STD-883
-
Test Method Standard Microcircuits.
MIL-STD-1835 - Interface Standard Electronic Component Case Outlines.
DEPARTMENT OF DEFENSE HANDBOOKS
MIL-HDBK-103 - List of Standard Microcircuit Drawings.
MIL-HDBK-780 - Standard Microcircuit Drawings.
(Copies of these documents are available online at https://assist.daps.dla.mil/quicksearch/ or from the Standardization
Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
2.2 Order of precedence. In the event of a conflict between the text of this drawing and the references cited herein, the text
of this drawing takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a
specific exemption has been obtained.
________
1/ Stresses above the absolute maximum rating may cause permanent damage to the device. Extended operation at the
maximum levels may degrade performance and affect reliability.
SIZE
STANDARD
MICROCIRCUIT DRAWING
5962-90537
A
DEFENSE SUPPLY CENTER COLUMBUS
COLUMBUS, OHIO 43218-3990
REVISION LEVEL
D
SHEET
3
DSCC FORM 2234
APR 97
ADI [ ADI ]
