欢迎访问ic37.com |
会员登录 免费注册
发布采购

AL10053N2DL 参数 Datasheet PDF下载

AL10053N2DL图片预览
型号: AL10053N2DL
PDF下载: 下载PDF文件 查看货源
内容描述: 薄膜片式电感器 [THIN FILM CHIP INDUCTOR]
分类和应用: 电感器
文件页数/大小: 66 页 / 368 K
品牌: ABC [ ABC Taiwan Electronics Corp ]
 浏览型号AL10053N2DL的Datasheet PDF文件第20页浏览型号AL10053N2DL的Datasheet PDF文件第21页浏览型号AL10053N2DL的Datasheet PDF文件第22页浏览型号AL10053N2DL的Datasheet PDF文件第23页浏览型号AL10053N2DL的Datasheet PDF文件第25页浏览型号AL10053N2DL的Datasheet PDF文件第26页浏览型号AL10053N2DL的Datasheet PDF文件第27页浏览型号AL10053N2DL的Datasheet PDF文件第28页  
AL103 Revision 1.0  
3.7.5 MAC Based Load Balancing  
For MAC address based load balancing, there is no need to assign a port to a trunk port. The AL103  
dynamically assigns MAC addresses to the trunk port. MAC address based trunks can consist of  
two, three, or four trunk ports. The bits are chosen for their randomness. The statistically random  
bits will ensure good load balancing among all trunk-ports.  
The following is a procedure to set up the MAC based load trunk.  
1. Select MAC address load trunking by setting bit 00.3 to “1.”  
2. Select the trunk ports using Port Configuration Register I bit 9.  
3. Assign the ports and the trunk port to the same VLAN using register 1E to 2C.  
4. When the number of trunk ports is four, the following steps are not required. If the  
number of trunk ports are two or three, set register bit 2D.8 (L2MAP) to “1.”  
5. Set the TrunkMap1 or TrunkMap0 in register bits 7 through 0. These bits indicate  
the mapping of trunk ports. For example, if ports 0 and 1 are used as trunk ports,  
then set the bits 2D.0 and 2D.1 to “1.” If ports 5 and 7 are used as trunk ports, set  
bits 2D.5 and 2D.7. The trunk port mapping and the trunk member bits set in Port  
Configuration I register must match.  
6. Finally, select the algorithm for MAC based loading. Set register 2D.10 to “1” for  
source address only, and “0” for the combination of source and destination  
addresses.  
The port VLAN grouping should include all the trunk ports. Since the AL103 will assign the port  
by MAC addresses, frames from any single port may be routed to any trunk ports.  
MAC Based Load Balancing Example  
The desired trunk port is 4, 5, 6, and 7. Therefore, the port configuration register bits 15.9, 17.9,  
19.9, and 1B.9 are set to “1.” Select MAC address loading by setting bit 00.3 to “1.”  
9/00  
Reference Only / Allayer Communications  
24  
 
 复制成功!