128Mb Synchronous DRAM
P2V28S20ATP-7,-75,-8 (4-BANK x 8,388,608-WORD x 4-BIT)
P2V28S30ATP-7,-75,-8 (4-BANK x 4,194,304-WORD x 8-BIT)
P2V28S40ATP-7,-75,-8 (4-BANK x 2,097,152-WORD x 16-BIT)
BASIC FUNCTIONS
The P2V28S20 , 30 and 40ATP provides basic functions,
bank (row) activate, burst read / write, bank (row) precharge,
and auto / self refresh.
A10 are used as chip select, refresh opt ion, and precharge
option, respectively .
Toknowthedetaileddefinitionofcommands,pleaseseethecom-
mandtruthtable.
Each command is defined by control signals of /RAS, /CAS and
/WE at CLK rising edge. In addition to 3 signals, /CS ,CKE and
CLK
/CS
/RAS
/CAS
/WE
Chip Select : L=select, H=deselect
Command
Command
Command
define basic command
CKE
A10
Refresh Option @ refresh command
Precharge Option @ precharge or read/write command
Activate (ACT) [/RAS =L, /CAS =/WE =H]
ACT command activates a row in an idle bank indicated by BA.
Read (READ) [/RAS =H, /CAS =L, /WE =H]
READ command starts burst read from the active bank indicated by BA. First output
data appears after /CAS latency. When A10 =H at this command, the bank is deac-
tivated after the burst read (auto-precharge, READA).
Write (WRITE) [/RAS =H, /CAS =/WE =L]
WRITE command starts burst write to the active bank indicated by BA. Total data
length to be written is set by burst length. When A10 =H at this command, the bank
is deactivated after the burst write (auto-precharge, WRITEA).
Precharge (PRE) [/RAS =L, /CAS =H, /WE =L]
PRE command deactivates the active bank indicated by BA. This command also
terminates burst read / write operation. When A10 =H at this command, all banks
are deactivated (precharge all, PREA ).
Auto-Refresh (REFA) [/RAS =/CAS =L, /WE =CKE =H]
REFA command starts auto-refresh cycle. Refresh address including bank address
are generated internally. After this command, the banks are precharged automatically.
JULY.2000
Rev.2.2
Page-5
VML [ VANGUARD INTERNATIONAL SEMICONDUCTOR ]
