January 2006
ASM2P20805A
rev 0.2
Absolute Maximum Ratings
Symbol
Description
Max
Unit
V
VCC
VI
Input Power Supply Voltage
-0.5 to +4.6
-0.5 to +5.5
Input Voltage
V
VO
TJ
Output Voltage
-0.5 to VCC+0.5
150
V
Junction Temperature
°C
°C
° C
Max. Soldering Temperature (10 sec)
Ts
260
TSTG
Storage Temperature
-65 to +165
Static Discharge Voltage
(As per JEDEC STD22- A114-B)
TDV
2
KV
Note: These are stress ratings only and are not implied for functional use. Exposure to absolute maximum ratings for prolonged periods of time may affect
device reliability.
DC Electrical Characteristics over Operating Range
Following Conditions Apply Unless Otherwise Specified
Industrial: TA = -40°C to +85°C, VCC = 2.5V ± 0.2V
Symbol
Parameter
Test Conditions1
Min
Typ2 Max
Unit
V
VIH
VIL
Input HIGH Level
1.7
-
5.5
0.7
±1
Input LOW Level
Input HIGH Current
Input LOW Current
-0.5
-
-
V
IIH
VCC= Max.
VCC= Max.
VI = 5.5V
-
IIL
VI = GND
VO = VCC
VO = GND
-
-
±1
µA
IOZH
IOZL
VIK
IODH
IODL
IOS
-
-
±1
High Impedance Output Current
(3-State Outputs Pins)
VCC= Max.
-
-
±1
Clamp Diode Voltage
Output HIGH Current
Output LOW Current
Short Circuit Current
VCC= Min., IIN = -18mA
CC= 2.5V, VIN = VIH or VIL, VO = 1.25V3,4
VCC= 2.5V, VIN = VIH or VIL, VO = 1.25V3,4
VCC= Max., VO = GND3,4
-
-15
-0.7
-35
55
-50
-
-1.2
-90
100
-120
-
V
mA
mA
mA
V
25
-30
1.75
VCC - 0.2
-
IOH= -8mA
VCC= Min.
VOH
Output HIGH Voltage
Output LOW Voltage
V
V
VIN = VIH or VIL
I
OH= -100µA
-
-
IOL= 8mA
0.2
0.4
VCC= Min.
IN = VIH or VIL
VOL
V
IOL= 100µA
-
-
0.2
Notes:
1. For conditions shown as Max. or Min., use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at VCC = 2.5V, 25°C ambient.
3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.
4. This parameter is guaranteed but not tested.
5. VOH = VCC -0.6V at rated current.
2.5V CMOS Dual 1-To-5 Clock Driver
3 of 12
Notice: The information in this document is subject to change without notice.