24LLC08
8K-Bit Serial EEPROM
Master
SCL Line
Bit 1
Bit 9
Data from
Transmitter
ACK from
Receiver
ACK
Figure 3-8. Acknowledge Response From Receiver
·
·
Slave Address: After the master initiates a Start condition, it must output the address of the device to be
accessed. The most significant four bits of the slave address are called the “device identifier”. The identifier
for the 24LLC08 is “1010B”. The next three bits comprise the address of a specific device. The device address
is defined by the state of the A0, A1 and A2 pins. Using this addressing scheme, you can cascade up to
two 24LLC08 on the bus (see Table 3-2 belos). The b1, b2 for 24LLC08 is used by the master to select witch
of the blocks of internal memory (1 block=256 words) are to be accessed. The bits are in effect the most
significant bits of the word address.
Read/Write: The final (eighth) bit of the slave address defines the type of operation to be performed. If the
R/W bit is “1”, a read operation is executed. If it is “0”, a write operation is executed.
Table 3-2. Slave Device Addressing
Device
Device Identifier
Device Address
R/W Bit
b0
b7 b6 b5 b4
b3
b2
b1
24LLC08
1
0
1
0
A2
B1
B0
R/W
* All specs and applications shown above subject to change without prior notice.
1F-5 NO.66 SEC.2 NAN-KAN RD ., LUCHU , TAOYUAN, TAIWAN
Tel:886-3-3214525
Email: server@ceramate.com.tw
Http: www.ceramate.com.tw
Rev 1.0 Nov. 18, 2002
Page 7 of 19
Fax:886-3-3521052
CERAMATE [ CERAMATE TECHNICAL ]
