2. Pins P85, P86, and P87 cannot be used. In order to use these pins, additional hardware must be
provided on the user board.
3. Area H’D000 to H’DFFF is used by the E10T, and is not available to the user.
4. Area H’F780 to H’FB7F must on no account be accessed.
5. When the E10T is used, address breaks can be set as either available to the user or for use by
the E10T. If address breaks are set as being used by the E10T, the address break control
registers must not be accessed.
6. When the E10T is used, NMI is an input/output pin (open-drain in output mode), P85 and P87
are input pins, and P86 is an output pin.
Related Manuals: The latest versions of all related manuals are available from our web site.
Please ensure you have the latest versions of all documents you require.
http://www.renesas.com/eng/
H8/3687 Group manuals:
Document Title
Document No.
This manual
H8/3687 Group Hardware Manual
H8/300H Series Programming Manual
ADE-602-053
User's manuals for development tools:
Document Title
Document No.
H8S, H8/300 Series C/C++ Compiler, Assembler, Optimizing Linkage Editor
User's Manual
ADE-702-247
H8S, H8/300 Series Simulator/Debugger User's Manual
ADE-702-282
ADE-702-231
H8S, H8/300 Series High-Performance Embedded Workshop,
High-Performance Debugging Interface Tutorial
High-Performance Embedded Workshop User's Manual
ADE-702-201
Application notes:
Document Title
Document No.
Single Power Supply F-ZTATTM On-Board Programming
ADE-502-055
Rev. 3.00, 05/03, page vii of xxx
ETC [ ETC ]
