Z8 Encore!® Motor Control Flash MCUs
Product Specification
226
Bit
Value
(H)
Description
Position
[7]
RESET/Fault0 Select
FLTSEL
0
1
RESET/Fault0 pin is configured as Fault0 input.
RESET/Fault0 pin is configured as RESET input.
[6]
Low Power Divide Mode Enable. See Oscillator Control chapter on page 231.
LPDEN
0
1
Low Power Divide mode is enabled
Low Power Divide mode is disabled
[5]
Must be 1.
Reserved
This Option Bit is reserved for future use and must always be 1.
[4]
PWM Output Pair PWM2 Enable
PWM2EN
0
1
PWM2 outputs are enabled and controlled by PWM logic.
PWM2 outputs are always high-impedance.
[3]
PWM Output Pair PWM1 Enable
PWM1EN
0
1
PWM1 outputs are enabled and controlled by PWM logic.
PWM1 outputs are always high-impedance.
[2]
PWM Output Pair PWM0 Enable
PWM0EN
0
1
PWM0 outputs are enabled and controlled by PWM logic.
PWM0 outputs are always high-impedance.
[1]
PWM High Side (PWM outputs 0H,1H, 2H) Default Off-State
PWM High-side inactive state is low, active state is High.
PWMHI
0
1
PWM High-side inactive state is high, active state is Low.
[0]
PWM Low Side (PWM outputs 0L,1L, 2L) Default Off-State
PWM Low-side inactive state is low, active state is high.
PWMLO
0
1
PWM Low-side inactive state is high, active state is low.
Option Bits
P R E L I M I N A R Y
PS024604-1005
ZILOG [ ZILOG, INC. ]
