Z8FMC16100 Series Flash MCU
Product Specification
125
After the valid data has been read, the OEbit of the Status 0 register is updated to indicate
the overrun condition (and Break Detect, if applicable). The RDAbit is set to 1 to indicate
that the Receive Data Register contains a data byte. However, because the overrun error
occurred, this byte may not contain valid data and must be ignored. The BRKDbit indicates
if the overrun was caused by a break condition on the line. After reading the status byte
indicating an overrun error, the Receive Data Register must be read again to clear the error
bits in the LIN-UART Status 0 register.
In LIN mode, an Overrun Error is signaled for receive data overruns as described above
and in the LIN Slave if the BRG Counter overflows during the autobaud sequence (the
ATBbit will also be set in this case). There is no data associated with the autobaud over-
flow interrupt, however the Receive Data Register must be read to clear the OEbit. In this
case software must write a 10B to the LinStatefield, forcing the LIN slave back to a
Wait for Break state.
LIN-UART Data- and Error-Handling Procedure
Figure 16 illustrates the recommended procedure for use in LIN-UART receiver interrupt
service routines.
PS024604-1005
P R E L I M I N A R Y
LIN-UART Interrupts
ZILOG [ ZILOG, INC. ]
