WM8750L
Production Data
ANALOGUE OUTPUTS
LOUT1/ROUT1 OUTPUTS
The LOUT1 and ROUT1 pins can drive a 16 or 32 headphone or a line output (see Headphone
Output and Line Output sections, respectively). The signal volume on LOUT1 and ROUT1 can be
independently adjusted under software control by writing to LOUT1VOL and ROUT1VOL,
respectively. Note that gains over 0dB may cause clipping if the signal is large. Any gain setting below
0101111 (minimum) mutes the output driver. The corresponding output pin remains at the same DC
level (the reference voltage on the VREF pin), so that no click noise is produced when muting or un-
muting.
A zero cross detect on the analogue output may also be enabled when changing the gain setting to
minimize audible clicks and zipper noise as the gain updates. If zero cross is enabled a timeout is
also available to update the gain if a zero cross does not occur. This function may be enabled by
setting TOEN in register R23 (17h).
REGISTER
ADDRESS
BIT
LABEL
LO1VU
DEFAULT
DESCRIPTION
R2 (02h)
LOUT1
Volume
Left Volume Update
8
0
0 = Store LOUT1VOL in intermediate
latch (no gain change)
1 = Update left and right channel gains
(left = LOUT1VOL, right = intermediate
latch)
LO1ZC
Left zero cross enable
1 = Change gain on zero cross only
0 = Change gain immediately
LOUT1 Volume
7
0
LOUT1VOL
[6:0]
6:0
1111001
(0dB)
1111111 = +6dB
… (80 steps)
0110000 = -67dB
0101111 to 0000000 = Analogue
MUTE
R3 (03h)
ROUT1
Volume
RO1VU
RO1ZC
Right Volume Update
8
0
0 = Store ROUT1VOL in intermediate
latch (no gain change)
1 = Update left and right channel gains
(left = intermediate latch, right =
ROUT1VOL)
Right zero cross enable
1 = Change gain on zero cross only
0 = Change gain immediately
ROUT1 Volume
7
0
ROUT1VOL
[6:0]
6:0
1111001
Similar to LOUT1VOL
Table 25 LOUT1/ROUT1 Volume Control
PD, Rev 4.4, August 2012
34
w
WOLFSON [ WOLFSON MICROELECTRONICS PLC ]
