W90N745CD/W90N745CDG
BITS
[31:8]
DESCRIPTIONS
Reserved
USB Class Command Decode Control Enable
0: Disable, the H/W circuit doesn’t need to decode USB class command.
It will return a stall status when it received a USB Class Command.
[7]
[6]
CCMD
VCMD
1: Enable, the H/W circuit decodes USB class command. It will assert
an interrupt event when it received a USB Class Command.
USB Vendor Command Decode Enable
0: Disable, the H/W circuit doesn’t need to decode USB vendor
command. It will return a stall status when it received a USB Vendor
Command.
1: Enable, the H/W circuit decodes USB vendor command. It will assert
an interrupt event when it received a USB Vendor Command.
USB SIE Differential RCV Source
0: RCV generated by the SIE
[5]
[4]
[3]
[2]
[1]
SIE_RCV
SUS_TST
RWU_EN
SUSP
1: RCV generated by the USB transceiver
USB Suspend Accelerate Test
0: Normal Operation
1: USB Suspend Accelerate Test (Only for Test)
USB Remote Wake-up Enable
0: Disable USB Remote Wake-Up Detect
1: Enable USB Remote Wake-Up Detect
USB Suspend Detect Enable
0: Disable USB Suspend Detect
1: Enable USB Suspend Detect
USB Engine Reset
0: Normal operation
1: Reset USB Engine
USB_RST
USB Engine Enable
0: disable USB Engine
1: enable USB Engine
[0]
USB_EN
Note: set this bit to “0”, the device is absent from host. After set
this bit to “1”, the host will detect a device attached.
Publication Release Date: September 22, 2006
- 193 -
Revision A2
WINBOND [ WINBOND ]
