Notes
1) Holdover and aging performance is after 7 days of power-on time.
2) Temperature stabilities apply to -20 to +70 ˚C modules. For other temperatures the temperature stability will
vary, however the hold over values over defined temperature ranges remain constant.
3) 24 hour average when locked to external 1PPS
4) The status locked indicator is intended to indicate when the module is fully locked to external 1 pps.
5) The Hardware OK indicator is intended to indicate when the module is operating properly without any failures
including hardware, software or parameter out of range, see protocol.
6) Open collector input bit.
7) If the minimum supply current is not exceeded, the Antenna Open Flag will be set. Over current will be set if
maximum is exceeded. Circuit has overcurrent protection.
8) The Rx pin is the serial interface input and the Tx pin is the serial interface output. The serial interface shall
operate at 9600 baud with eight (8) data bits, one (1) stop bit and no parity.
9) This holdover performance also applies to the temperature deviation over the entire operating range of -20 to
+70˚C.
Application Notes
1) Holdover Contributions and Calculations - please contact for a copy
2) Vectron Discipline and Hold Over Process and Algorithms - please contact us for a copy
3) Utilizing Disciplined Oscillators as Frequency References - please contact factory
For Additional Information, Please Contact
8
USA:
Europe:
Asia:
Vectron International
267 Lowell Road
Hudson, NH 03051
Tel: 1.888.328.7661
Vectron International
Vectron International
Landstrasse, D-74924
Neckarbischofsheim, Germany
Tel: +49 (0) 7268.801.100
1F-2F, No 8 Workshop, No 308 Fenju Road
WaiGaoQiao Free Trade Zone
Pudong, Shanghai, China 200131
Tel: 86.21.5048.0777
Fax: 1.888.329.8328
Fax: +49 (0) 7268.801.282
Fax: 86.21.5048.1881
Disclaimer
Vectron International reserves the right to make changes to the product(s) and or information contained herein without notice. No liability is assumed as a result of their use or application.
No rights under any patent accompany the sale of any such product(s) or information.
Rev: 100509 dmc
Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com
8